[PATCH v4 net-next 08/10] mips: dts: ralink: mt7621: change mt7530 switch address

[Arınç ÜNAL]

In the case of muxing phy0 of the MT7530 switch, the switch and the phy
will have the same address on the mdio bus, 0. This causes the ethernet
driver to fail since devices on the mdio bus cannot share an address.

Any address can be used for the switch, therefore, change the switch
address to 0x1f.

Suggested-by: Sungbo Eo <mans0n at gorani.run>
Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
Reviewed-by: Sergio Paracuellos <sergio.paracuellos at gmail.com>
---
 arch/mips/boot/dts/ralink/mt7621.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/mips/boot/dts/ralink/mt7621.dtsi b/arch/mips/boot/dts/ralink/mt7621.dtsi
index edb7dd8b34da..f3f4c1f26e01 100644
--- a/arch/mips/boot/dts/ralink/mt7621.dtsi
+++ b/arch/mips/boot/dts/ralink/mt7621.dtsi
@@ -340,9 +340,9 @@ mdio: mdio-bus {
 			#address-cells = <1>;
 			#size-cells = <0>;
 
-			switch0: switch at 0 {
+			switch0: switch at 1f {
 				compatible = "mediatek,mt7621";
-				reg = <0>;
+				reg = <0x1f>;
 				mediatek,mcm;
 				resets = <&sysc MT7621_RST_MCM>;
 				reset-names = "mcm";
-- 
2.34.1