[PATCH net-next v2 4/5] net: mediatek: sgmii: set the speed according to the phy interface in AN

[Alexander Couzens]

The non auto-negotioting code path is setting the correct speed for the
interface. Ensure auto-negotiation code path is doing it as well.

Signed-off-by: Alexander Couzens <lynxis at fe80.eu>
---
 drivers/net/ethernet/mediatek/mtk_sgmii.c | 11 +++++++++--
 1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/mediatek/mtk_sgmii.c b/drivers/net/ethernet/mediatek/mtk_sgmii.c
index 6f4c1ca5a36f..4c8e8c7b1d32 100644
--- a/drivers/net/ethernet/mediatek/mtk_sgmii.c
+++ b/drivers/net/ethernet/mediatek/mtk_sgmii.c
@@ -21,13 +21,20 @@ static struct mtk_pcs *pcs_to_mtk_pcs(struct phylink_pcs *pcs)
 }
 
 /* For SGMII interface mode */
-static int mtk_pcs_setup_mode_an(struct mtk_pcs *mpcs)
+static int mtk_pcs_setup_mode_an(struct mtk_pcs *mpcs, phy_interface_t interface)
 {
 	unsigned int val;
 
 	/* PHYA power down */
 	regmap_write(mpcs->regmap, SGMSYS_QPHY_PWR_STATE_CTRL, SGMII_PHYA_PWD);
 
+	/* Set SGMII phy speed */
+	regmap_read(mpcs->regmap, mpcs->ana_rgc3, &val);
+	val &= ~RG_PHY_SPEED_MASK;
+	if (interface == PHY_INTERFACE_MODE_2500BASEX)
+		val |= RG_PHY_SPEED_3_125G;
+	regmap_write(mpcs->regmap, mpcs->ana_rgc3, val);
+
 	/* Setup the link timer and QPHY power up inside SGMIISYS */
 	regmap_write(mpcs->regmap, SGMSYS_PCS_LINK_TIMER,
 		     SGMII_LINK_TIMER_DEFAULT);
@@ -112,7 +119,7 @@ static int mtk_pcs_config(struct phylink_pcs *pcs, unsigned int mode,
 	if (interface != PHY_INTERFACE_MODE_SGMII)
 		err = mtk_pcs_setup_mode_force(mpcs, interface);
 	else if (phylink_autoneg_inband(mode))
-		err = mtk_pcs_setup_mode_an(mpcs);
+		err = mtk_pcs_setup_mode_an(mpcs, interface);
 
 	return err;
 }
-- 
2.37.3