[PATCH 08/10] mips: dts: ralink: mt7621: change mt7530 switch address

[Sergio Paracuellos]

On Wed, Sep 14, 2022 at 10:56 AM Arınç ÜNAL <arinc.unal at arinc9.com> wrote:
>
> In the case of muxing phy0 of the MT7530 switch, the switch and the phy
> will have the same address on the mdio bus, 0. This causes the ethernet
> driver to fail since devices on the mdio bus cannot share an address.
>
> Any address can be used for the switch, therefore, change the switch
> address to 0x1f.
>
> Suggested-by: Sungbo Eo <mans0n at gorani.run>
> Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
> ---
>  arch/mips/boot/dts/ralink/mt7621.dtsi | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)

Reviewed-by: Sergio Paracuellos <sergio.paracuellos at gmail.com>

Thanks,
    Sergio Paracuellos