[PATCH v6 2/3] iommu/mediatek: Introduce new flag TF_PORT_TO_ADDR_MT8173

[AngeloGioacchino Del Regno]

In preparation for adding support for MT6795, add a new flag named
TF_PORT_TO_ADDR_MT8173 and use that instead of checking for m4u_plat
type in mtk_iommu_hw_init() to avoid seeing a long list of m4u_plat
checks there in the future.

Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno at collabora.com>
Reviewed-by: Yong Wu <yong.wu at mediatek.com>
---
 drivers/iommu/mtk_iommu.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/iommu/mtk_iommu.c b/drivers/iommu/mtk_iommu.c
index 7e363b1f24df..b511359376f4 100644
--- a/drivers/iommu/mtk_iommu.c
+++ b/drivers/iommu/mtk_iommu.c
@@ -138,6 +138,7 @@
 #define PM_CLK_AO			BIT(15)
 #define IFA_IOMMU_PCIE_SUPPORT		BIT(16)
 #define PGTABLE_PA_35_EN		BIT(17)
+#define TF_PORT_TO_ADDR_MT8173		BIT(18)
 
 #define MTK_IOMMU_HAS_FLAG_MASK(pdata, _x, mask)	\
 				((((pdata)->flags) & (mask)) == (_x))
@@ -955,7 +956,7 @@ static int mtk_iommu_hw_init(const struct mtk_iommu_data *data, unsigned int ban
 	 * Global control settings are in bank0. May re-init these global registers
 	 * since no sure if there is bank0 consumers.
 	 */
-	if (data->plat_data->m4u_plat == M4U_MT8173) {
+	if (MTK_IOMMU_HAS_FLAG(data->plat_data, TF_PORT_TO_ADDR_MT8173)) {
 		regval = F_MMU_PREFETCH_RT_REPLACE_MOD |
 			 F_MMU_TF_PROT_TO_PROGRAM_ADDR_MT8173;
 	} else {
@@ -1427,7 +1428,8 @@ static const struct mtk_iommu_plat_data mt8167_data = {
 static const struct mtk_iommu_plat_data mt8173_data = {
 	.m4u_plat     = M4U_MT8173,
 	.flags	      = HAS_4GB_MODE | HAS_BCLK | RESET_AXI |
-			HAS_LEGACY_IVRP_PADDR | MTK_IOMMU_TYPE_MM,
+			HAS_LEGACY_IVRP_PADDR | MTK_IOMMU_TYPE_MM |
+			TF_PORT_TO_ADDR_MT8173,
 	.inv_sel_reg  = REG_MMU_INV_SEL_GEN1,
 	.banks_num    = 1,
 	.banks_enable = {true},
-- 
2.37.2