[PATCH] arm64: dts: imx8mp-venice-gw74xx: add PCIe support

[Alexander Stein]

Hi Tim,

Am Donnerstag, 8. September 2022, 17:49:03 CEST schrieb Tim Harvey:
> Add PCIe support on the Gateworks GW74xx board. While at it,
> fix the related gpio line names from the previous incorrect values.
> 
> Signed-off-by: Tim Harvey <tharvey at gateworks.com>
> ---
>  .../dts/freescale/imx8mp-venice-gw74xx.dts    | 40 +++++++++++++++++--
>  1 file changed, 37 insertions(+), 3 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mp-venice-gw74xx.dts
> b/arch/arm64/boot/dts/freescale/imx8mp-venice-gw74xx.dts index
> e0fe356b662d..7644db61d631 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mp-venice-gw74xx.dts
> +++ b/arch/arm64/boot/dts/freescale/imx8mp-venice-gw74xx.dts
> @@ -8,6 +8,7 @@
>  #include <dt-bindings/gpio/gpio.h>
>  #include <dt-bindings/input/linux-event-codes.h>
>  #include <dt-bindings/leds/common.h>
> +#include <dt-bindings/phy/phy-imx8-pcie.h>
> 
>  #include "imx8mp.dtsi"
> 
> @@ -100,6 +101,12 @@ led-1 {
>  		};
>  	};
> 
> +	pcie0_refclk: pcie0-refclk {
> +		compatible = "fixed-clock";
> +		#clock-cells = <0>;
> +		clock-frequency = <100000000>;
> +	};
> +
>  	pps {
>  		compatible = "pps-gpio";
>  		pinctrl-names = "default";
> @@ -215,8 +222,8 @@ &gpio1 {
>  &gpio2 {
>  	gpio-line-names =
>  		"", "", "", "", "", "", "", "",
> -		"", "", "", "", "", "", "", "",
> -		"pcie3_wdis#", "", "", "pcie1_wdis@", "pcie2_wdis#", "", 
"", "",
> +		"", "", "", "", "", "", "pcie3_wdis#", "",
> +		"", "", "pcie2_wdis#", "", "", "", "", "",
>  		"", "", "", "", "", "", "", "";
>  };
> 
> @@ -562,6 +569,28 @@ &i2c4 {
>  	status = "okay";
>  };
> 
> +&pcie_phy {
> +	fsl,refclk-pad-mode = <IMX8_PCIE_REFCLK_PAD_INPUT>;
> +	fsl,clkreq-unsupported;
> +	clocks = <&pcie0_refclk>;
> +	clock-names = "ref";
> +	status = "okay";
> +};
> +
> +&pcie {
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&pinctrl_pcie0>;
> +	reset-gpio = <&gpio2 17 GPIO_ACTIVE_LOW>;
> +	clocks = <&clk IMX8MP_CLK_HSIO_ROOT>,
> +		 <&clk IMX8MP_CLK_PCIE_ROOT>,
> +		 <&clk IMX8MP_CLK_HSIO_AXI>;
> +	clock-names = "pcie", "pcie_aux", "pcie_bus";

With the still pending dt-binding patch at [1] the clock order shall be
"pcie", "pcie_bus", "pcie_phy".

Best regards,
Alexander

[1] https://lore.kernel.org/lkml/20220822184701.25246-2-Sergey.Semin@baikalelectronics.ru/

> +	assigned-clocks = <&clk IMX8MP_CLK_PCIE_AUX>;
> +	assigned-clock-rates = <10000000>;
> +	assigned-clock-parents = <&clk IMX8MP_SYS_PLL2_50M>;
> +	status = "okay";
> +};
> +
>  /* GPS / off-board header */
>  &uart1 {
>  	pinctrl-names = "default";
> @@ -694,7 +723,6 @@ pinctrl_hog: hoggrp {
>  			MX8MP_IOMUXC_GPIO1_IO09__GPIO1_IO09	
0x40000040 /* DIO0 */
>  			MX8MP_IOMUXC_GPIO1_IO11__GPIO1_IO11	
0x40000040 /* DIO1 */
>  			MX8MP_IOMUXC_NAND_DQS__GPIO3_IO14	0x40000040 /
* M2SKT_OFF# */
> -			MX8MP_IOMUXC_SD2_DATA2__GPIO2_IO17	
0x40000150 /* PCIE1_WDIS# */
>  			MX8MP_IOMUXC_SD2_DATA3__GPIO2_IO18	
0x40000150 /* PCIE2_WDIS# */
>  			MX8MP_IOMUXC_SD2_CMD__GPIO2_IO14	0x40000150 /
* PCIE3_WDIS# */
>  			MX8MP_IOMUXC_NAND_DATA00__GPIO3_IO06	
0x40000040 /* M2SKT_RST# */
> @@ -807,6 +835,12 @@ MX8MP_IOMUXC_SD2_DATA1__GPIO2_IO16	0x10
> 
>  		>;
> 
>  	};
> 
> +	pinctrl_pcie0: pciegrp {
> +		fsl,pins = <
> +			MX8MP_IOMUXC_SD2_DATA2__GPIO2_IO17	
0x110
> +		>;
> +	};
> +
>  	pinctrl_pmic: pmicgrp {
>  		fsl,pins = <
>  			MX8MP_IOMUXC_NAND_DATA01__GPIO3_IO07	
0x140