[PATCH] arm64: dts: rockchip: Fix SD card controller probe on Pinephone Pro

[Nícolas F. R. A. Prado]

On Mon, Sep 05, 2022 at 01:36:47AM +0200, Ondrej Jirman wrote:
> Voltage constraints on vccio_sd are invalid. They don't match the voltages
> that LDO9 can generate, and this causes rk808-regulator driver to fail
> to probe with -EINVAL when it tries to apply the constraints during boot.
> 
> Fix the constraints to something that LDO9 can be actually configured for.
> 
> Fixes: 78a21c7d5952 ("arm64: dts: rockchip: Add initial support for Pine64 PinePhone Pro")
> Signed-off-by: Ondrej Jirman <megi at xff.cz>
> ---
>  arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts b/arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts
> index f00c80361377a..2e058c3150256 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts
> +++ b/arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts
> @@ -253,8 +253,8 @@ regulator-state-mem {
>  
>  			vccio_sd: LDO_REG9 {
>  				regulator-name = "vccio_sd";
> -				regulator-min-microvolt = <1710000>;
> -				regulator-max-microvolt = <3150000>;
> +				regulator-min-microvolt = <1800000>;
> +				regulator-max-microvolt = <3300000>;

Shouldn't the maximum be 3.1V? The SDMMC0_VDD pin on RK3399 that this regulator
is connected to expects a maximum voltage of 3.15V, so 3.3V would be too high.
The output voltage for LDO9 is configured in 100mV steps, so I imagine that's
why 3.15V fails, but 3.1V should work fine. I haven't tested yet though.

Thanks,
Nícolas