[PATCH v3 00/10] gpiolib: Handle immutable irq_chip structures

Andy Shevchenko andy.shevchenko at gmail.com
Thu May 12 10:35:55 PDT 2022


On Thu, May 12, 2022 at 08:08:28PM +0300, Andy Shevchenko wrote:
> On Tue, Apr 19, 2022 at 03:18:36PM +0100, Marc Zyngier wrote:
> > This is a followup from [2].
> > 
> > I recently realised that the gpiolib play ugly tricks on the
> > unsuspecting irq_chip structures by patching the callbacks.
> > 
> > Not only this breaks when an irq_chip structure is made const (which
> > really should be the default case), but it also forces this structure
> > to be copied at nauseam for each instance of the GPIO block, which is
> > a waste of memory.
> 
> Is this brings us to the issue with IRQ chip name?
> 
> The use case in my mind is the following:
> 1) we have two or more GPIO chips that supports IRQ;
> 2) the user registers two IRQs of the same (by number) pin on different chips;
> 3) cat /proc/interrupt will show 'my_gpio_chip XX', where XX is the number.
> 
> So, do I understand correct current state of affairs?
> 
> If so, we have to fix this to have any kind of ID added to the chip name that
> we can map /proc/interrupts output correctly.

Hmm... Some drivers are using static names, some -- dynamically prepared (one
way or another). Either way I think the ID is good to have if we still miss it.

-- 
With Best Regards,
Andy Shevchenko





More information about the linux-arm-kernel mailing list