[RFC v8 net-next 06/16] pinctrl: microchip-sgpio: add ability to be used in a non-mmio configuration

[Andy Shevchenko]

On Sun, May 8, 2022 at 8:53 PM Colin Foster
<colin.foster at in-advantage.com> wrote:
>
> There are a few Ocelot chips that can contain SGPIO logic, but can be
> controlled externally. Specifically the VSC7511, 7512, 7513, and 7514. In
> the externally controlled configurations these registers are not
> memory-mapped.
>
> Add support for these non-memory-mapped configurations.

...

> -       regs = devm_platform_ioremap_resource(pdev, 0);
> -       if (IS_ERR(regs))
> -               return PTR_ERR(regs);
> +       regs = devm_platform_get_and_ioremap_resource(pdev, 0, NULL);
> +       if (IS_ERR(regs)) {
> +               /*
> +                * Fall back to using IORESOURCE_REG, which is possible in an
> +                * MFD configuration
> +                */
> +               res = platform_get_resource(pdev, IORESOURCE_REG, 0);
> +               if (!res) {
> +                       dev_err(dev, "Failed to get resource\n");
> +                       return -ENODEV;
> +               }
> +
> +               priv->regs = ocelot_init_regmap_from_resource(dev, res);
> +       } else {
> +               priv->regs = devm_regmap_init_mmio(dev, regs, &regmap_config);
> +       }
>
> -       priv->regs = devm_regmap_init_mmio(dev, regs, &regmap_config);
>         if (IS_ERR(priv->regs))
>                 return PTR_ERR(priv->regs);

This looks like repetition of something you have done in a few
previous patches. Can you avoid code duplication by introducing a
corresponding helper function?

-- 
With Best Regards,
Andy Shevchenko