[PATCH V2 1/6] dt-bindings: remoteproc: imx_rproc: support i.MX8QXP

[Peng Fan (OSS)]

From: Peng Fan <peng.fan at nxp.com>

Add i.MX8QXP compatible

Add a new property rsrc-id(resource id) for SoC which supports
SCFW(System Controller Firmware). SCFW manages resources using resource
id, here the rsrc-id is used to check whether remote process is under
control of Linux or not.

To i.MX8QM/QXP, when M4 is in the same hardware partition with Cortex-A
cores, need power up M4 through SCFW, then M4 could start. So introduce
power-domains property.

Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
 .../bindings/remoteproc/fsl,imx-rproc.yaml        | 15 +++++++++++++++
 1 file changed, 15 insertions(+)

diff --git a/Documentation/devicetree/bindings/remoteproc/fsl,imx-rproc.yaml b/Documentation/devicetree/bindings/remoteproc/fsl,imx-rproc.yaml
index fc16d903353e..f25c203dd2f9 100644
--- a/Documentation/devicetree/bindings/remoteproc/fsl,imx-rproc.yaml
+++ b/Documentation/devicetree/bindings/remoteproc/fsl,imx-rproc.yaml
@@ -19,6 +19,7 @@ properties:
       - fsl,imx8mm-cm4
       - fsl,imx8mn-cm7
       - fsl,imx8mp-cm7
+      - fsl,imx8qxp-cm4
       - fsl,imx8ulp-cm33
       - fsl,imx7d-cm4
       - fsl,imx7ulp-cm4
@@ -27,6 +28,11 @@ properties:
   clocks:
     maxItems: 1
 
+  entry:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    description: |
+      Specify cpu entry address for SCU enabled processor.
+
   syscon:
     $ref: /schemas/types.yaml#/definitions/phandle
     description:
@@ -59,6 +65,15 @@ properties:
       Indicate whether need to load the default firmware and start the remote
       processor automatically.
 
+  power-domains:
+    maxItems: 8
+
+  rsrc-id:
+    description:
+      This property is to specify the resource id of the remote processor in SoC
+      which supports SCFW
+    maxItems: 1
+
 required:
   - compatible
 
-- 
2.30.0