[PATCH V7 5/6] tty: serial: meson: The system stuck when you run the stty command on the console to change the baud rate

Jerome Brunet jbrunet at baylibre.com
Mon Feb 28 02:58:30 PST 2022


On Fri 25 Feb 2022 at 15:39, Yu Tu <yu.tu at amlogic.com> wrote:

> Start the console and run the following commands in turn:
> stty -F /dev/ttyAML0 115200 and stty -F /dev/ttyAML0 921600. The
> system will stuck.
>
> Signed-off-by: Yu Tu <yu.tu at amlogic.com>
> ---
>  drivers/tty/serial/meson_uart.c | 5 +++++
>  1 file changed, 5 insertions(+)
>
> diff --git a/drivers/tty/serial/meson_uart.c b/drivers/tty/serial/meson_uart.c
> index ba8dc203b9cb..d19349ead738 100644
> --- a/drivers/tty/serial/meson_uart.c
> +++ b/drivers/tty/serial/meson_uart.c
> @@ -365,8 +365,13 @@ static void meson_uart_set_termios(struct uart_port *port,
>  	writel(val, port->membase + AML_UART_CONTROL);
>  
>  	baud = uart_get_baud_rate(port, termios, old, 50, 4000000);
> +
> +	spin_unlock_irqrestore(&port->lock, flags);
> +
>  	meson_uart_change_speed(port, baud);
>  
> +	spin_lock_irqsave(&port->lock, flags);

Already told you before, you can make meson_change_speed()
clk_set_rate() uses mutex and may sleep.

> +
>  	port->read_status_mask = AML_UART_TX_FIFO_WERR;
>  	if (iflags & INPCK)
>  		port->read_status_mask |= AML_UART_PARITY_ERR |




More information about the linux-arm-kernel mailing list