[PATCH] arm64: dts: imx8ulp: Set #thermal-sensor-cells to 1 as required

[Peng Fan]

> Subject: [PATCH] arm64: dts: imx8ulp: Set #thermal-sensor-cells to 1 as
> required
> 
> The SCMI binding clearly states the value of #thermal-sensor-cells must be 1.
> However arch/arm64/boot/dts/freescale/imx8ulp.dtsi sets it 0 which results
> in the following warning with dtbs_check:
> 
>   |  arch/arm64/boot/dts/freescale/imx8ulp-evk.dt.yaml: scmi:
>   | 		protocol at 15:#thermal-sensor-cells:0:0: 1 was expected
>   |	From schema:
> Documentation/devicetree/bindings/firmware/arm,scmi.yaml
> 
> Fix it by setting it to 1 as required.
> 
> Cc:Shawn Guo <shawnguo at kernel.org>
> Cc: Sascha Hauer <s.hauer at pengutronix.de>
> Signed-off-by: Sudeep Holla <sudeep.holla at arm.com>

Acked-by: Peng Fan <peng.fan at nxp.com>

> ---
>  arch/arm64/boot/dts/freescale/imx8ulp.dtsi | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8ulp.dtsi
> b/arch/arm64/boot/dts/freescale/imx8ulp.dtsi
> index a987ff7156bd..09f7364dd1d0 100644
> --- a/arch/arm64/boot/dts/freescale/imx8ulp.dtsi
> +++ b/arch/arm64/boot/dts/freescale/imx8ulp.dtsi
> @@ -132,7 +132,7 @@ scmi_devpd: protocol at 11 {
> 
>  			scmi_sensor: protocol at 15 {
>  				reg = <0x15>;
> -				#thermal-sensor-cells = <0>;
> +				#thermal-sensor-cells = <1>;
>  			};
>  		};
>  	};
> --
> 2.25.1