[PATCH 2/2] imx6qdl.dtsi: use MAC-address from nvmem

[Shawn Guo]

On Wed, Nov 02, 2022 at 03:27:19PM +0100, Nikolaus Voss wrote:
> IMX6QDL has fuse locations specified for storing the MAC for the
> built-in ethernet (Table 5-8 in Reference Manual).
> Define the fuse location in ocotp and refer to them in fec-ethernet.
> 
> If the cells are not flashed, the driver behavior is unchanged, i.e.
> other MAC sources will be probed and a random MAC will be used as a
> last resort.
> 
> Signed-off-by: Nikolaus Voss <nikolaus.voss at haag-streit.com>
> ---
>  arch/arm/boot/dts/imx6qdl.dtsi | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/imx6qdl.dtsi b/arch/arm/boot/dts/imx6qdl.dtsi
> index 4f7fefc14d0ac..7449d554ef1aa 100644
> --- a/arch/arm/boot/dts/imx6qdl.dtsi
> +++ b/arch/arm/boot/dts/imx6qdl.dtsi
> @@ -1053,6 +1053,8 @@ fec: ethernet at 2188000 {
>  					 <&clks IMX6QDL_CLK_ENET_REF>;
>  				clock-names = "ipg", "ahb", "ptp", "enet_out";
>  				fsl,stop-mode = <&gpr 0x34 27>;
> +				nvmem-cells = <&fec_mac_addr>;
> +				nvmem-cell-names = "mac-address";

May I ask where is the support of FEC driver for this?

Shawn

>  				status = "disabled";
>  			};
>  
> @@ -1186,6 +1188,10 @@ tempmon_calib: calib at 38 {
>  				tempmon_temp_grade: temp-grade at 20 {
>  					reg = <0x20 4>;
>  				};
> +
> +				fec_mac_addr: mac-addr at 88 {
> +					reg = <0x88 6>;
> +				};
>  			};
>  
>  			tzasc at 21d0000 { /* TZASC1 */
> -- 
> 2.34.1
>