[PATCH 1/3] dt-bindings: spi: stm32: Add st,dual-flash property in st,stm32-qspi.yaml

[Krzysztof Kozlowski]

On 08/08/2022 10:40, patrice.chotard at foss.st.com wrote:
> From: Patrice Chotard <patrice.chotard at foss.st.com>
> 
> Add new property st,dual-flash which allows to use the QSPI interface as a
> communication channel using up to 8 qspi line.
> This mode can only be used if cs-gpios property is defined.
> 
> Signed-off-by: Patrice Chotard <patrice.chotard at foss.st.com>
> ---
>  Documentation/devicetree/bindings/spi/st,stm32-qspi.yaml | 8 ++++++++
>  1 file changed, 8 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/spi/st,stm32-qspi.yaml b/Documentation/devicetree/bindings/spi/st,stm32-qspi.yaml
> index 6ec6f556182f..5e4f9109799e 100644
> --- a/Documentation/devicetree/bindings/spi/st,stm32-qspi.yaml
> +++ b/Documentation/devicetree/bindings/spi/st,stm32-qspi.yaml
> @@ -46,6 +46,14 @@ properties:
>        - const: tx
>        - const: rx
>  
> +  st,dual-flash:
> +    type: boolean
> +    description:
> +      Allows to use 8 data lines in case cs-gpios property is defined.

It's named dual-flash, but what if you want to use QSPI to connect for
example to FPGA?

Also how is this related to parallel-memories property?

Best regards,
Krzysztof