[EXT] [PATCH v2 04/16] ARM: dts: ls1021a-qds: Add node for QSPI flash

[Kuldeep Singh]

Hi Leo,

> -----Original Message-----
> From: Li Yang <leoyang.li at nxp.com>
> Sent: Friday, October 1, 2021 5:34 AM
> To: Shawn Guo <shawnguo at kernel.org>; Rob Herring
> <robh+dt at kernel.org>; devicetree at vger.kernel.org; Oleksij Rempel
> <linux at rempel-privat.de>; linux-arm-kernel at lists.infradead.org; linux-
> kernel at vger.kernel.org
> Cc: Leo Li <leoyang.li at nxp.com>
> Subject: [EXT] [PATCH v2 04/16] ARM: dts: ls1021a-qds: Add node for QSPI
> flash
> 
> Caution: EXT Email
> 
> Add the missing node for qspi flash.
> 
> Signed-off-by: Li Yang <leoyang.li at nxp.com>
> ---
>  arch/arm/boot/dts/ls1021a-qds.dts | 15 +++++++++++++++
>  1 file changed, 15 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/ls1021a-qds.dts
> b/arch/arm/boot/dts/ls1021a-qds.dts
> index e2aa569ff404..522e1dc51059 100644
> --- a/arch/arm/boot/dts/ls1021a-qds.dts
> +++ b/arch/arm/boot/dts/ls1021a-qds.dts
> @@ -286,6 +286,21 @@ tbi0: tbi-phy at 8 {
>         };
>  };
> 
> +&qspi {
> +       num-cs = <2>;

Please drop "num-cs" property as it is not used by qspi driver.

> +       status = "okay";
> +
> +       qflash0: flash at 0 {

Can we have flash chip name instead of qflash?
There is no hard requirement, it will help in aligning node properties with other board properties such as LX2160A-RDB, LS1046A-RDB etc.

With above fixed,
Reviewed-by: Kuldeep Singh <kuldeep.singh at nxp.com>

> +               compatible = "jedec,spi-nor";
> +               #address-cells = <1>;
> +               #size-cells = <1>;
> +               spi-max-frequency = <20000000>;
> +               reg = <0>;
> +               spi-rx-bus-width = <4>;
> +               spi-tx-bus-width = <4>;
> +       };
> +};
> +
>  &sai2 {
>         status = "okay";
>  };
> --
> 2.25.1