[PATCH 2/8] arm64: dts: imx8mm-kontron: Make sure SOC and DRAM supply voltages are correct

[Frieder Schrempf]

From: Frieder Schrempf <frieder.schrempf at kontron.de>

VDD_SOC should be 800 mV in suspend and 850 mV in run mode. VDD_DRAM
should be 950 mV for DDR clock frequencies of 1.5 GHz.

This information is taken from the datasheet and the uboot-imx code.

Signed-off-by: Frieder Schrempf <frieder.schrempf at kontron.de>
---
 arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi
index 03b3516abd64..b12fb7ce6686 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi
@@ -92,10 +92,12 @@ regulators {
 			reg_vdd_soc: BUCK1 {
 				regulator-name = "buck1";
 				regulator-min-microvolt = <800000>;
-				regulator-max-microvolt = <900000>;
+				regulator-max-microvolt = <850000>;
 				regulator-boot-on;
 				regulator-always-on;
 				regulator-ramp-delay = <3125>;
+				nxp,dvs-run-voltage = <850000>;
+				nxp,dvs-standby-voltage = <800000>;
 			};
 
 			reg_vdd_arm: BUCK2 {
@@ -111,7 +113,7 @@ reg_vdd_arm: BUCK2 {
 			reg_vdd_dram: BUCK3 {
 				regulator-name = "buck3";
 				regulator-min-microvolt = <850000>;
-				regulator-max-microvolt = <900000>;
+				regulator-max-microvolt = <950000>;
 				regulator-boot-on;
 				regulator-always-on;
 			};
-- 
2.33.0