[PATCH 1/1] ARM: dts: stm32: fix AV96 board SAI2B pin muxing on stm32mp15

[Marek Vasut]

On 9/30/21 5:05 PM, Alexandre TORGUE wrote:
> On 9/30/21 12:26 PM, Marek Vasut wrote:
>> On 9/30/21 10:47 AM, Alexandre TORGUE wrote:
>>> Hi Marek
>>>
>>> On 9/29/21 1:18 PM, Marek Vasut wrote:
>>>> On 9/27/21 1:45 PM, Olivier Moysan wrote:
>>>>> Fix SAI2B pin muxing for AV96 board on STM32MP15.
>>>>> The label "sai2a-4" is defined twice. Change redundant label to 
>>>>> "sai2b-4".
>>>>>
>>>>> Fixes: dcf185ca8175 ("ARM: dts: stm32: Add alternate pinmux for 
>>>>> SAI2 pins on stm32mp15")
>>>>>
>>>>> Signed-off-by: Olivier Moysan <olivier.moysan at foss.st.com>
>>>>> ---
>>>>>   arch/arm/boot/dts/stm32mp15-pinctrl.dtsi | 2 +-
>>>>>   1 file changed, 1 insertion(+), 1 deletion(-)
>>>>>
>>>>> diff --git a/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi 
>>>>> b/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
>>>>> index 5b60ecbd718f..b9cc9e0dd4fc 100644
>>>>> --- a/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
>>>>> +++ b/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
>>>>> @@ -1235,7 +1235,7 @@
>>>>>           };
>>>>>       };
>>>>> -    sai2b_pins_c: sai2a-4 {
>>>>> +    sai2b_pins_c: sai2b-4 {
>>>>>           pins1 {
>>>>>               pinmux = <STM32_PINMUX('F', 11, AF10)>; /* SAI2_SD_B */
>>>>>               bias-disable;
>>>>
>>>> This mp1 pinmuxing is a total mess, sigh.
>>>
>>> What is the issue here ?
>>
>> The same-old discussion about where to place the pinmux nodes, whether 
>> we should have these clusters of pre-defined options in 
>> ...pinctrl.dtsi, or whether we should do more nxp-like per-board 
>> configuration.
> 
> ok it's a bit more precise. Honestly I don't understand why the current 
> topology is an issue here. Maybe pinctrl SAI nodes names are not well 
> chosen or are not enough explicit. Concerning our topology and the NXP 
> ones both exists and both have advantages and drawbacks. For ST boards 
> (DK/EV) we want to keep all configs in the same place.
> 
> As I prefer to not re open this topic again and again, feel free to add 
> your pin config in your dts board file, I'll accept it.

Yes, let's not reopen it. I'm sorry if my grumbling came across as too 
strong.