[PATCH 06/12] regulator: dt-bindings: samsung, s5m8767: convert to dtschema

[Krzysztof Kozlowski]

On 28/09/2021 10:49, Krzysztof Kozlowski wrote:
> Convert the regulators of Samsung S5M8767 PMIC to DT schema format.
> 
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at canonical.com>
> ---
>  .../bindings/regulator/samsung,s5m8767.txt    | 23 +----
>  .../bindings/regulator/samsung,s5m8767.yaml   | 83 +++++++++++++++++++
>  MAINTAINERS                                   |  2 +-
>  3 files changed, 85 insertions(+), 23 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/regulator/samsung,s5m8767.yaml
> 
> diff --git a/Documentation/devicetree/bindings/regulator/samsung,s5m8767.txt b/Documentation/devicetree/bindings/regulator/samsung,s5m8767.txt
> index 6cd83d920155..a1c6eb6f07c8 100644
> --- a/Documentation/devicetree/bindings/regulator/samsung,s5m8767.txt
> +++ b/Documentation/devicetree/bindings/regulator/samsung,s5m8767.txt
> @@ -48,28 +48,7 @@ Additional properties required if either of the optional properties are used:
>     for dvs. The format of the gpio specifier depends in the gpio controller.
>  
>  
> -Names of regulators supported by S5M8767 device:
> -	- LDOn
> -		  - valid values for n are 1 to 28
> -		  - Example: LDO1, LDO2, LDO28
> -	- BUCKn
> -		  - valid values for n are 1 to 9.
> -		  - Example: BUCK1, BUCK2, BUCK9
> -Note: The 'n' in LDOn and BUCKn represents the LDO or BUCK number
> -as per the datasheet of device.
> -
> -
> -Optional properties of the nodes under "regulators" sub-node:
> - - op_mode: describes the different operating modes of the LDO's with
> -            power mode change in SOC. The different possible values are,
> -             0 - always off mode
> -             1 - on in normal mode
> -             2 - low power mode
> -             3 - suspend mode
> - - s5m8767,pmic-ext-control-gpios: (optional) GPIO specifier for one
> -                                   GPIO controlling this regulator
> -                                   (enable/disable); This is valid only
> -                                   for buck9.
> +

That's obviously not sufficient - I will remove full file in v2.

Best regards,
Krzysztof