[PATCHv2 0/5] arm64/irqentry: remove duplicate housekeeping of
Paul E. McKenney
paulmck at kernel.org
Mon Sep 27 17:09:22 PDT 2021
On Mon, Sep 27, 2021 at 10:23:18AM +0100, Mark Rutland wrote:
> On Fri, Sep 24, 2021 at 03:59:54PM -0700, Paul E. McKenney wrote:
> > On Fri, Sep 24, 2021 at 06:36:15PM +0100, Mark Rutland wrote:
> > > [Adding Paul for RCU, s390 folk for entry code RCU semantics]
> > >
> > > On Fri, Sep 24, 2021 at 09:28:32PM +0800, Pingfan Liu wrote:
> > > > After introducing arm64/kernel/entry_common.c which is akin to
> > > > kernel/entry/common.c , the housekeeping of rcu/trace are done twice as
> > > > the following:
> > > > enter_from_kernel_mode()->rcu_irq_enter().
> > > > And
> > > > gic_handle_irq()->...->handle_domain_irq()->irq_enter()->rcu_irq_enter()
> > > >
> > > > Besides redundance, based on code analysis, the redundance also raise
> > > > some mistake, e.g. rcu_data->dynticks_nmi_nesting inc 2, which causes
> > > > rcu_is_cpu_rrupt_from_idle() unexpected.
> > >
> > > Hmmm...
> > >
> > > The fundamental questionss are:
> > >
> > > 1) Who is supposed to be responsible for doing the rcu entry/exit?
> > >
> > > 2) Is it supposed to matter if this happens multiple times?
> > >
> > > For (1), I'd generally expect that this is supposed to happen in the
> > > arch/common entry code, since that itself (or the irqchip driver) could
> > > depend on RCU, and if that's the case thatn handle_domain_irq()
> > > shouldn't need to call rcu_irq_enter(). That would be consistent with
> > > the way we handle all other exceptions.
> > >
> > > For (2) I don't know whether the level of nesting is suppoosed to
> > > matter. I was under the impression it wasn't meant to matter in general,
> > > so I'm a little surprised that rcu_is_cpu_rrupt_from_idle() depends on a
> > > specific level of nesting.
> > >
> > > >From a glance it looks like this would cause rcu_sched_clock_irq() to
> > > skip setting TIF_NEED_RESCHED, and to not call invoke_rcu_core(), which
> > > doesn't sound right, at least...
> > >
> > > Thomas, Paul, thoughts?
> >
> > It is absolutely required that rcu_irq_enter() and rcu_irq_exit() calls
> > be balanced. Normally, this is taken care of by the fact that irq_enter()
> > invokes rcu_irq_enter() and irq_exit() invokes rcu_irq_exit(). Similarly,
> > nmi_enter() invokes rcu_nmi_enter() and nmi_exit() invokes rcu_nmi_exit().
>
> Sure; I didn't mean to suggest those weren't balanced! The problem here
> is *nesting*. Due to the structure of our entry code and the core IRQ
> code, when handling an IRQ we have a sequence:
>
> irq_enter() // arch code
> irq_enter() // irq code
>
> < irq handler here >
>
> irq_exit() // irq code
> irq_exit() // arch code
>
> ... and if we use something like rcu_is_cpu_rrupt_from_idle() in the
> middle (e.g. as part of rcu_sched_clock_irq()), this will not give the
> expected result because of the additional nesting, since
> rcu_is_cpu_rrupt_from_idle() seems to expect that dynticks_nmi_nesting
> is only incremented once per exception entry, when it does:
>
> /* Are we at first interrupt nesting level? */
> nesting = __this_cpu_read(rcu_data.dynticks_nmi_nesting);
> if (nesting > 1)
> return false;
>
> What I'm trying to figure out is whether that expectation is legitimate,
> and assuming so, where the entry/exit should happen.
Oooh...
The penalty for fooling rcu_is_cpu_rrupt_from_idle() is that RCU will
be unable to detect a userspace quiescent state for a non-nohz_full
CPU. That could result in RCU CPU stall warnings if a user task runs
continuously on a given CPU for more than 21 seconds (60 seconds in
some distros). And this can easily happen if the user has a CPU-bound
thread that is the only runnable task on that CPU.
So, yes, this does need some sort of resolution.
The traditional approach is (as you surmise) to have only a single call
to irq_enter() on exception entry and only a single call to irq_exit()
on exception exit. If this is feasible, it is highly recommended.
In theory, we could have that "1" in "nesting > 1" be a constant supplied
by the architecture (you would want "3" if I remember correctly) but
in practice could we please avoid this? For one thing, if there is
some other path into the kernel for your architecture that does only a
single irq_enter(), then rcu_is_cpu_rrupt_from_idle() just doesn't stand
a chance. It would need to compare against a different value depending
on what exception showed up. Even if that cannot happen, it would be
better if your architecture could remain in blissful ignorance of the
colorful details of ->dynticks_nmi_nesting manipulations.
Another approach would be for the arch code to supply RCU a function that
it calls. If there is such a function (or perhaps better, if some new
Kconfig option is enabled), RCU invokes it. Otherwise, it compares to
"1" as it does now. But you break it, you buy it! ;-)
Thoughts? Other approaches?
Thanx, Paul
> Thanks,
> Mark.
>
> > But if you are doing some special-case exception where the handler needs
> > to use RCU readers, but where the rest of the work is not needed, then
> > the resulting calls to rcu_irq_enter() and rcu_irq_exit() must be in
> > the architecture-specific code and must be properly balanced.
> >
> > So if exception entry invokes rcu_irq_enter() twice, then exception
> > exit also needs to invoke rcu_irq_exit() twice.
> >
> > There are some constraints on where calls to these functions are place.
> > For example, any exception-entry code prior to the call to rcu_irq_enter()
> > must consist solely of functions marked noinstr, but Thomas can tell
> > you more.
> >
> > Or am I missing the point of your question?
> >
> > Thanx, Paul
> >
> > > AFAICT, s390 will have a similar flow on its IRQ handling path, so if
> > > this is a real issue they'll be affected too.
> > >
> > > Thanks,
> > > Mark.
> > >
> > > > Nmi also faces duplicate accounts. This series aims to address these
> > > > duplicate issues.
> > > > [1-2/5]: address nmi account duplicate
> > > > [3-4/5]: address rcu housekeeping duplicate in irq
> > > > [5/5]: as a natural result of [3-4/5], address a history issue. [1]
> > > >
> > > >
> > > > History:
> > > > v1 -> v2:
> > > > change the subject as the motivation varies.
> > > > add the fix for nmi account duplicate
> > > >
> > > > The subject of v1 is "[PATCH 1/3] kernel/irq: __handle_domain_irq()
> > > > makes irq_enter/exit arch optional". [2] It is brought up to fix [1].
> > > >
> > > > There have been some tries to enable crash-stop-NMI on arm64, one by me,
> > > > the other by Yuichi's [4]. I hope after this series, they can advance,
> > > > as Marc said in [3] "No additional NMI patches will make it until we
> > > > have resolved the issues"
> > > >
> > > > [1] https://lore.kernel.org/linux-arm-kernel/87lfewnmdz.fsf@nanos.tec.linutronix.de/
> > > > [2] https://lore.kernel.org/linux-arm-kernel/1607912752-12481-1-git-send-email-kernelfans@gmail.com
> > > > [3] https://lore.kernel.org/linux-arm-kernel/afd82be798cb55fd2f96940db7be78c0@kernel.org
> > > > [4] https://lore.kernel.org/linux-arm-kernel/20201104080539.3205889-1-ito-yuichi@fujitsu.com
> > > >
> > > > Cc: Catalin Marinas <catalin.marinas at arm.com>
> > > > Cc: Will Deacon <will at kernel.org>
> > > > Cc: Mark Rutland <mark.rutland at arm.com>
> > > > Cc: Marc Zyngier <maz at kernel.org>
> > > > Cc: Joey Gouly <joey.gouly at arm.com>
> > > > Cc: Sami Tolvanen <samitolvanen at google.com>
> > > > Cc: Julien Thierry <julien.thierry at arm.com>
> > > > Cc: Thomas Gleixner <tglx at linutronix.de>
> > > > Cc: Yuichi Ito <ito-yuichi at fujitsu.com>
> > > > Cc: linux-kernel at vger.kernel.org
> > > > To: linux-arm-kernel at lists.infradead.org
> > > >
> > > >
> > > > Pingfan Liu (5):
> > > > arm64/entry-common: push the judgement of nmi ahead
> > > > irqchip/GICv3: expose handle_nmi() directly
> > > > kernel/irq: make irq_{enter,exit}() in handle_domain_irq() arch
> > > > optional
> > > > irqchip/GICv3: let gic_handle_irq() utilize irqentry on arm64
> > > > irqchip/GICv3: make reschedule-ipi light weight
> > > >
> > > > arch/arm64/Kconfig | 1 +
> > > > arch/arm64/include/asm/irq.h | 7 ++++
> > > > arch/arm64/kernel/entry-common.c | 45 +++++++++++++++-------
> > > > arch/arm64/kernel/irq.c | 29 ++++++++++++++
> > > > drivers/irqchip/irq-gic-v3.c | 66 ++++++++++++++++++++------------
> > > > kernel/irq/Kconfig | 3 ++
> > > > kernel/irq/irqdesc.c | 4 ++
> > > > 7 files changed, 116 insertions(+), 39 deletions(-)
> > > >
> > > > --
> > > > 2.31.1
> > > >
More information about the linux-arm-kernel
mailing list