Hi,
This patch adds support for Microchip External Interrupt Controller
present on SAMA7G5. The controller supports for 2 external interrupt
lines and is connected to GIC as follows:
pinX +------+ EXT_IRQ0 +------+ int 153 (for pinX) +------+
------>| |--------->| |------------------->| |
pinY | PIO | EXT_IRQ1 | EIC | int 154 (for pinY) | GIC |
------>| |--------->| |------------------->| |
+------+ +------+ +------+
where PIO is the pin controller.
Thank you,
Claudiu Beznea
Changes in v2:
- s/mchp/microchip in bindings
- get rid of glitch filter settings
- use s/eic@/interrupt-controller@ in bindings
- removed '' around interrupts in bindings as proposed by Rob
- removed glitch filter settings
- switched to hierarchical irqchip driver
- addressed review comments
- use builtin_platform_driver instead of module_platform_driver
Claudiu Beznea (2):
dt-bindings: microchip,eic: add bindings
irqchip/mchp-eic: add support
.../interrupt-controller/microchip,eic.yaml | 73 ++++
MAINTAINERS | 6 +
drivers/irqchip/Kconfig | 8 +
drivers/irqchip/Makefile | 1 +
drivers/irqchip/irq-mchp-eic.c | 314 ++++++++++++++++++
5 files changed, 402 insertions(+)
create mode 100644 Documentation/devicetree/bindings/interrupt-controller/microchip,eic.yaml
create mode 100644 drivers/irqchip/irq-mchp-eic.c
--
2.25.1