[PATCH 04/22] PCI: iproc: Use SET_PCI_ERROR_RESPONSE() when device not found

[Naveen Naidu]

An MMIO read from a PCI device that doesn't exist or doesn't respond
causes a PCI error.  There's no real data to return to satisfy the
CPU read, so most hardware fabricates ~0 data.

Use SET_PCI_ERROR_RESPONSE() to set the error response, when a faulty
hardware read occurs.

This helps unify PCI error response checking and make error check
consistent and easier to find.

Signed-off-by: Naveen Naidu <naveennaidu479 at gmail.com>
---
 drivers/pci/controller/pcie-iproc.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/pci/controller/pcie-iproc.c b/drivers/pci/controller/pcie-iproc.c
index 30ac5fbefbbf..f182dc2cdb0c 100644
--- a/drivers/pci/controller/pcie-iproc.c
+++ b/drivers/pci/controller/pcie-iproc.c
@@ -660,7 +660,7 @@ static int iproc_pci_raw_config_read32(struct iproc_pcie *pcie,
 
 	addr = iproc_pcie_map_cfg_bus(pcie, 0, devfn, where & ~0x3);
 	if (!addr) {
-		*val = ~0;
+		SET_PCI_ERROR_RESPONSE(val);
 		return PCIBIOS_DEVICE_NOT_FOUND;
 	}
 
-- 
2.25.1