[RFC PATCH v4 net-next 12/23] pinctrl: ocelot: convert pinctrl to regmap
Colin Foster
colin.foster at in-advantage.com
Mon Nov 15 22:23:17 PST 2021
In order to allow external control via SPI, memory-mapped areas must be
changed to use the generic regmap interface. This is step 1, and is
followed by an implementation that allows a custom regmap.
Signed-off-by: Colin Foster <colin.foster at in-advantage.com>
---
drivers/pinctrl/pinctrl-ocelot.c | 66 ++++++++++++++++++++++++++------
1 file changed, 55 insertions(+), 11 deletions(-)
diff --git a/drivers/pinctrl/pinctrl-ocelot.c b/drivers/pinctrl/pinctrl-ocelot.c
index f015404c425c..b9acb80d6b3f 100644
--- a/drivers/pinctrl/pinctrl-ocelot.c
+++ b/drivers/pinctrl/pinctrl-ocelot.c
@@ -152,7 +152,7 @@ struct ocelot_pinctrl {
struct pinctrl_dev *pctl;
struct gpio_chip gpio_chip;
struct regmap *map;
- void __iomem *pincfg;
+ struct regmap *pincfg;
struct pinctrl_desc *desc;
struct ocelot_pmx_func func[FUNC_MAX];
u8 stride;
@@ -819,7 +819,11 @@ static int ocelot_hw_get_value(struct ocelot_pinctrl *info,
int ret = -EOPNOTSUPP;
if (info->pincfg) {
- u32 regcfg = readl(info->pincfg + (pin * sizeof(u32)));
+ u32 regcfg;
+
+ ret = regmap_read(info->pincfg, pin, ®cfg);
+ if (ret)
+ return ret;
ret = 0;
switch (reg) {
@@ -843,6 +847,24 @@ static int ocelot_hw_get_value(struct ocelot_pinctrl *info,
return ret;
}
+static int ocelot_pincfg_clrsetbits(struct ocelot_pinctrl *info, u32 regaddr,
+ u32 clrbits, u32 setbits)
+{
+ u32 val;
+ int ret;
+
+ ret = regmap_read(info->pincfg, regaddr, &val);
+ if (ret)
+ return ret;
+
+ val &= ~clrbits;
+ val |= setbits;
+
+ ret = regmap_write(info->pincfg, regaddr, val);
+
+ return ret;
+}
+
static int ocelot_hw_set_value(struct ocelot_pinctrl *info,
unsigned int pin,
unsigned int reg,
@@ -851,21 +873,23 @@ static int ocelot_hw_set_value(struct ocelot_pinctrl *info,
int ret = -EOPNOTSUPP;
if (info->pincfg) {
- void __iomem *regaddr = info->pincfg + (pin * sizeof(u32));
ret = 0;
switch (reg) {
case PINCONF_BIAS:
- ocelot_clrsetbits(regaddr, BIAS_BITS, val);
+ ret = ocelot_pincfg_clrsetbits(info, pin, BIAS_BITS,
+ val);
break;
case PINCONF_SCHMITT:
- ocelot_clrsetbits(regaddr, SCHMITT_BIT, val);
+ ret = ocelot_pincfg_clrsetbits(info, pin, SCHMITT_BIT,
+ val);
break;
case PINCONF_DRIVE_STRENGTH:
if (val <= 3)
- ocelot_clrsetbits(regaddr, DRIVE_BITS, val);
+ ret = ocelot_pincfg_clrsetbits(info, pin,
+ DRIVE_BITS, val);
else
ret = -EINVAL;
break;
@@ -1340,12 +1364,32 @@ static const struct of_device_id ocelot_pinctrl_of_match[] = {
{},
};
+static struct regmap *ocelot_pinctrl_create_pincfg(struct platform_device *pdev)
+{
+ void __iomem *base;
+
+ const struct regmap_config regmap_config = {
+ .reg_bits = 32,
+ .val_bits = 32,
+ .reg_stride = 4,
+ .max_register = 32,
+ };
+
+ base = devm_platform_ioremap_resource(pdev, 0);
+ if (IS_ERR(base)) {
+ dev_dbg(&pdev->dev, "Failed to ioremap config registers (no extended pinconf)\n");
+ return NULL;
+ }
+
+ return devm_regmap_init_mmio(&pdev->dev, base, ®map_config);
+}
+
static int ocelot_pinctrl_probe(struct platform_device *pdev)
{
struct device *dev = &pdev->dev;
struct ocelot_pinctrl *info;
+ struct regmap *pincfg;
void __iomem *base;
- struct resource *res;
int ret;
struct regmap_config regmap_config = {
.reg_bits = 32,
@@ -1378,11 +1422,11 @@ static int ocelot_pinctrl_probe(struct platform_device *pdev)
/* Pinconf registers */
if (info->desc->confops) {
- base = devm_platform_ioremap_resource(pdev, 0);
- if (IS_ERR(base))
- dev_dbg(dev, "Failed to ioremap config registers (no extended pinconf)\n");
+ pincfg = ocelot_pinctrl_create_pincfg(pdev);
+ if (IS_ERR(pincfg))
+ dev_dbg(dev, "Failed to create pincfg regmap\n");
else
- info->pincfg = base;
+ info->pincfg = pincfg;
}
ret = ocelot_pinctrl_register(pdev, info);
--
2.25.1
More information about the linux-arm-kernel
mailing list