[PATCH 02/11] dt-bindings: pci: layerscape-pci: define aer/pme interrupts

[Li Yang]

Some platforms using this controller have separated interrupt lines for
aer or pme events instead of having a single interrupt line for
miscellaneous events.  Define interrupts in the binding for these
interrupt lines.

Signed-off-by: Li Yang <leoyang.li at nxp.com>
---
 .../devicetree/bindings/pci/layerscape-pci.txt     | 14 ++++++++++----
 1 file changed, 10 insertions(+), 4 deletions(-)

diff --git a/Documentation/devicetree/bindings/pci/layerscape-pci.txt b/Documentation/devicetree/bindings/pci/layerscape-pci.txt
index 0d3d78aebe26..5697fe078072 100644
--- a/Documentation/devicetree/bindings/pci/layerscape-pci.txt
+++ b/Documentation/devicetree/bindings/pci/layerscape-pci.txt
@@ -31,8 +31,13 @@ Required properties:
 - reg: base addresses and lengths of the PCIe controller register blocks.
 - interrupts: A list of interrupt outputs of the controller. Must contain an
   entry for each entry in the interrupt-names property.
-- interrupt-names: Must include the following entries:
-  "intr": The interrupt that is asserted for controller interrupts
+- interrupt-names: It could include the following entries:
+  "aer": For interrupt line reporting aer events when non MSI/MSI-X/INTx mode
+		is used
+  "pme": For interrupt line reporting pme events when non MSI/MSI-X/INTx mode
+		is used
+  "intr": For interrupt line reporting miscellaneous controller events
+  ......
 - fsl,pcie-scfg: Must include two entries.
   The first entry must be a link to the SCFG device node
   The second entry must be '0' or '1' based on physical PCIe controller index.
@@ -48,8 +53,9 @@ Example:
 		reg = <0x00 0x03400000 0x0 0x00010000   /* controller registers */
 		       0x40 0x00000000 0x0 0x00002000>; /* configuration space */
 		reg-names = "regs", "config";
-		interrupts = <GIC_SPI 177 IRQ_TYPE_LEVEL_HIGH>; /* controller interrupt */
-		interrupt-names = "intr";
+		interrupts = <GIC_SPI 176 IRQ_TYPE_LEVEL_HIGH>, /* aer interrupt */
+			<GIC_SPI 177 IRQ_TYPE_LEVEL_HIGH>; /* pme interrupt */
+		interrupt-names = "aer", "pme";
 		fsl,pcie-scfg = <&scfg 0>;
 		#address-cells = <3>;
 		#size-cells = <2>;
-- 
2.25.1