[PATCH] arm: remove zte zx platform left-over

[Lukas Bulwahn]

Commit 89d4f98ae90d ("ARM: remove zte zx platform") missed to remove some
definitions for this platform's debug and serial, e.g., code dependent on
the config DEBUG_ZTE_ZX.

Fortunately, ./scripts/checkkconfigsymbols.py detects this and warns:

DEBUG_ZTE_ZX
Referencing files: arch/arm/include/debug/pl01x.S

Further review by Arnd Bergmann identified even more dead code in the
amba serial driver.

Remove all this left-over from the zte zx platform.

Signed-off-by: Lukas Bulwahn <lukas.bulwahn at gmail.com>
---
this is a new patch after the discussion around:

https://lore.kernel.org/all/20211028141938.3530-2-lukas.bulwahn@gmail.com/

 arch/arm/include/debug/pl01x.S  |  7 -------
 drivers/tty/serial/amba-pl011.c | 37 ---------------------------------
 include/linux/amba/bus.h        |  6 ------
 3 files changed, 50 deletions(-)

diff --git a/arch/arm/include/debug/pl01x.S b/arch/arm/include/debug/pl01x.S
index 0c7bfa4c10db..c7e02d0628bf 100644
--- a/arch/arm/include/debug/pl01x.S
+++ b/arch/arm/include/debug/pl01x.S
@@ -8,13 +8,6 @@
 */
 #include <linux/amba/serial.h>
 
-#ifdef CONFIG_DEBUG_ZTE_ZX
-#undef UART01x_DR
-#undef UART01x_FR
-#define UART01x_DR     0x04
-#define UART01x_FR     0x14
-#endif
-
 #ifdef CONFIG_DEBUG_UART_PHYS
 		.macro	addruart, rp, rv, tmp
 		ldr	\rp, =CONFIG_DEBUG_UART_PHYS
diff --git a/drivers/tty/serial/amba-pl011.c b/drivers/tty/serial/amba-pl011.c
index d361cd84ff8c..c9534e229166 100644
--- a/drivers/tty/serial/amba-pl011.c
+++ b/drivers/tty/serial/amba-pl011.c
@@ -188,38 +188,6 @@ static struct vendor_data vendor_st = {
 	.get_fifosize		= get_fifosize_st,
 };
 
-static const u16 pl011_zte_offsets[REG_ARRAY_SIZE] = {
-	[REG_DR] = ZX_UART011_DR,
-	[REG_FR] = ZX_UART011_FR,
-	[REG_LCRH_RX] = ZX_UART011_LCRH,
-	[REG_LCRH_TX] = ZX_UART011_LCRH,
-	[REG_IBRD] = ZX_UART011_IBRD,
-	[REG_FBRD] = ZX_UART011_FBRD,
-	[REG_CR] = ZX_UART011_CR,
-	[REG_IFLS] = ZX_UART011_IFLS,
-	[REG_IMSC] = ZX_UART011_IMSC,
-	[REG_RIS] = ZX_UART011_RIS,
-	[REG_MIS] = ZX_UART011_MIS,
-	[REG_ICR] = ZX_UART011_ICR,
-	[REG_DMACR] = ZX_UART011_DMACR,
-};
-
-static unsigned int get_fifosize_zte(struct amba_device *dev)
-{
-	return 16;
-}
-
-static struct vendor_data vendor_zte = {
-	.reg_offset		= pl011_zte_offsets,
-	.access_32b		= true,
-	.ifls			= UART011_IFLS_RX4_8|UART011_IFLS_TX4_8,
-	.fr_busy		= ZX_UART01x_FR_BUSY,
-	.fr_dsr			= ZX_UART01x_FR_DSR,
-	.fr_cts			= ZX_UART01x_FR_CTS,
-	.fr_ri			= ZX_UART011_FR_RI,
-	.get_fifosize		= get_fifosize_zte,
-};
-
 /* Deals with DMA transactions */
 
 struct pl011_sgbuf {
@@ -2974,11 +2942,6 @@ static const struct amba_id pl011_ids[] = {
 		.mask	= 0x00ffffff,
 		.data	= &vendor_st,
 	},
-	{
-		.id	= AMBA_LINUX_ID(0x00, 0x1, 0xffe),
-		.mask	= 0x00ffffff,
-		.data	= &vendor_zte,
-	},
 	{ 0, 0 },
 };
 
diff --git a/include/linux/amba/bus.h b/include/linux/amba/bus.h
index edfcf7a14dcd..6c7f47846971 100644
--- a/include/linux/amba/bus.h
+++ b/include/linux/amba/bus.h
@@ -90,14 +90,8 @@ enum amba_vendor {
 	AMBA_VENDOR_ST = 0x80,
 	AMBA_VENDOR_QCOM = 0x51,
 	AMBA_VENDOR_LSI = 0xb6,
-	AMBA_VENDOR_LINUX = 0xfe,	/* This value is not official */
 };
 
-/* This is used to generate pseudo-ID for AMBA device */
-#define AMBA_LINUX_ID(conf, rev, part) \
-	(((conf) & 0xff) << 24 | ((rev) & 0xf) << 20 | \
-	AMBA_VENDOR_LINUX << 12 | ((part) & 0xfff))
-
 extern struct bus_type amba_bustype;
 
 #define to_amba_device(d)	container_of(d, struct amba_device, dev)
-- 
2.26.2