[PATCH 04/10] media: hantro: add support for Rockchip RK3066

Alex Bee knaerzche at gmail.com
Wed May 26 16:22:05 PDT 2021


Hi Ezequiel,

thanks for your feedback.

Am 26.05.21 um 12:32 schrieb Ezequiel Garcia:
> Hi Alex,
>
> Thanks for the patch.
>
> On Tue, 2021-05-25 at 17:22 +0200, Alex Bee wrote:
>> RK3066's VPU IP block is the predecessor from what RK3288 has.
>> The hardware differences are:
>>    - supports decoding frame sizes up to 1920x1088 only
>>    - doesn't have the 'G1_REG_SOFT_RESET' register
>>      (requires another .reset callback for hantro_codec_ops,
>>       since writing this register will result in non-working
>>       IP block)
>>    - has one ACLK/HCLK per vdpu/vepu
>>    - ACLKs can be clocked up to 300 MHz only
>>    - no MMU
>>      (no changes required: CMA will be transparently used)
>>
>> Add a new RK3066 variant which reflect this differences. This variant
>> can be used for RK3188 as well.
>>
>> Signed-off-by: Alex Bee <knaerzche at gmail.com>
>> ---
>>   drivers/staging/media/hantro/hantro_drv.c    |   1 +
>>   drivers/staging/media/hantro/hantro_hw.h     |   1 +
>>   drivers/staging/media/hantro/rk3288_vpu_hw.c | 116 +++++++++++++++++++
>>   3 files changed, 118 insertions(+)
>>
>> diff --git a/drivers/staging/media/hantro/hantro_drv.c b/drivers/staging/media/hantro/hantro_drv.c
>> index 2f6b01c7a6a0..38ea7b24036e 100644
>> --- a/drivers/staging/media/hantro/hantro_drv.c
>> +++ b/drivers/staging/media/hantro/hantro_drv.c
>> @@ -489,6 +489,7 @@ static const struct of_device_id of_hantro_match[] = {
>>          { .compatible = "rockchip,rk3399-vpu", .data = &rk3399_vpu_variant, },
>>          { .compatible = "rockchip,rk3328-vpu", .data = &rk3328_vpu_variant, },
>>          { .compatible = "rockchip,rk3288-vpu", .data = &rk3288_vpu_variant, },
>> +       { .compatible = "rockchip,rk3066-vpu", .data = &rk3066_vpu_variant, },
>>   #endif
>>   #ifdef CONFIG_VIDEO_HANTRO_IMX8M
>>          { .compatible = "nxp,imx8mq-vpu", .data = &imx8mq_vpu_variant, },
>> diff --git a/drivers/staging/media/hantro/hantro_hw.h b/drivers/staging/media/hantro/hantro_hw.h
>> index 3d8b53567f16..de2bc367a15a 100644
>> --- a/drivers/staging/media/hantro/hantro_hw.h
>> +++ b/drivers/staging/media/hantro/hantro_hw.h
>> @@ -163,6 +163,7 @@ enum hantro_enc_fmt {
>>   extern const struct hantro_variant rk3399_vpu_variant;
>>   extern const struct hantro_variant rk3328_vpu_variant;
>>   extern const struct hantro_variant rk3288_vpu_variant;
>> +extern const struct hantro_variant rk3066_vpu_variant;
>>   extern const struct hantro_variant imx8mq_vpu_variant;
>>   extern const struct hantro_variant sama5d4_vdec_variant;
>>   
>> diff --git a/drivers/staging/media/hantro/rk3288_vpu_hw.c b/drivers/staging/media/hantro/rk3288_vpu_hw.c
>> index fefd45269e52..29805c4bd92f 100644
>> --- a/drivers/staging/media/hantro/rk3288_vpu_hw.c
>> +++ b/drivers/staging/media/hantro/rk3288_vpu_hw.c
>> @@ -10,8 +10,10 @@
>>   
>>   #include "hantro.h"
>>   #include "hantro_jpeg.h"
>> +#include "hantro_g1_regs.h"
>>   #include "hantro_h1_regs.h"
>>   
>> +#define RK3066_ACLK_MAX_FREQ (300 * 1000 * 1000)
>>   #define RK3288_ACLK_MAX_FREQ (400 * 1000 * 1000)
>>   
>>   /*
>> @@ -62,6 +64,52 @@ static const struct hantro_fmt rk3288_vpu_postproc_fmts[] = {
>>          },
>>   };
>>   
>> +static const struct hantro_fmt rk3066_vpu_dec_fmts[] = {
>> +       {
>> +               .fourcc = V4L2_PIX_FMT_NV12,
>> +               .codec_mode = HANTRO_MODE_NONE,
>> +       },
>> +       {
>> +               .fourcc = V4L2_PIX_FMT_H264_SLICE,
>> +               .codec_mode = HANTRO_MODE_H264_DEC,
>> +               .max_depth = 2,
>> +               .frmsize = {
>> +                       .min_width = 48,
>> +                       .max_width = 1920,
>> +                       .step_width = MB_DIM,
>> +                       .min_height = 48,
>> +                       .max_height = 1088,
>> +                       .step_height = MB_DIM,
>> +               },
>> +       },
>> +       {
>> +               .fourcc = V4L2_PIX_FMT_MPEG2_SLICE,
>> +               .codec_mode = HANTRO_MODE_MPEG2_DEC,
>> +               .max_depth = 2,
>> +               .frmsize = {
>> +                       .min_width = 48,
>> +                       .max_width = 1920,
>> +                       .step_width = MB_DIM,
>> +                       .min_height = 48,
>> +                       .max_height = 1088,
>> +                       .step_height = MB_DIM,
>> +               },
>> +       },
>> +       {
>> +               .fourcc = V4L2_PIX_FMT_VP8_FRAME,
>> +               .codec_mode = HANTRO_MODE_VP8_DEC,
>> +               .max_depth = 2,
>> +               .frmsize = {
>> +                       .min_width = 48,
>> +                       .max_width = 1920,
>> +                       .step_width = MB_DIM,
>> +                       .min_height = 48,
>> +                       .max_height = 1088,
>> +                       .step_height = MB_DIM,
>> +               },
>> +       },
>> +};
>> +
>>   static const struct hantro_fmt rk3288_vpu_dec_fmts[] = {
>>          {
>>                  .fourcc = V4L2_PIX_FMT_NV12,
>> @@ -126,6 +174,14 @@ static irqreturn_t rk3288_vepu_irq(int irq, void *dev_id)
>>          return IRQ_HANDLED;
>>   }
>>   
>> +static int rk3066_vpu_hw_init(struct hantro_dev *vpu)
>> +{
>> +       /* Bump ACLKs to max. possible freq. to improve performance. */
>> +       clk_set_rate(vpu->clocks[0].clk, RK3066_ACLK_MAX_FREQ);
>> +       clk_set_rate(vpu->clocks[0].clk, RK3066_ACLK_MAX_FREQ);
>> +       return 0;
>> +}
>> +
>>   static int rk3288_vpu_hw_init(struct hantro_dev *vpu)
>>   {
>>          /* Bump ACLK to max. possible freq. to improve performance. */
>> @@ -133,6 +189,14 @@ static int rk3288_vpu_hw_init(struct hantro_dev *vpu)
>>          return 0;
>>   }
>>   
>> +static void rk3066_vpu_dec_reset(struct hantro_ctx *ctx)
>> +{
>> +       struct hantro_dev *vpu = ctx->dev;
>> +
>> +       vdpu_write(vpu, G1_REG_INTERRUPT_DEC_IRQ_DIS, G1_REG_INTERRUPT);
>> +       vdpu_write(vpu, G1_REG_CONFIG_DEC_CLK_GATE_E, G1_REG_CONFIG);
>> +}
>> +
>>   static void rk3288_vpu_enc_reset(struct hantro_ctx *ctx)
>>   {
>>          struct hantro_dev *vpu = ctx->dev;
>> @@ -145,6 +209,33 @@ static void rk3288_vpu_enc_reset(struct hantro_ctx *ctx)
>>   /*
>>    * Supported codec ops.
>>    */
>> +static const struct hantro_codec_ops rk3066_vpu_codec_ops[] = {
>> +       [HANTRO_MODE_JPEG_ENC] = {
>> +               .run = hantro_h1_jpeg_enc_run,
>> +               .reset = rk3288_vpu_enc_reset,
>> +               .init = hantro_jpeg_enc_init,
>> +               .done = hantro_jpeg_enc_done,
>> +               .exit = hantro_jpeg_enc_exit,
>> +       },
>> +       [HANTRO_MODE_H264_DEC] = {
>> +               .run = hantro_g1_h264_dec_run,
>> +               .reset = rk3066_vpu_dec_reset,
>> +               .init = hantro_h264_dec_init,
>> +               .exit = hantro_h264_dec_exit,
>> +       },
>> +       [HANTRO_MODE_MPEG2_DEC] = {
>> +               .run = hantro_g1_mpeg2_dec_run,
>> +               .reset = rk3066_vpu_dec_reset,
>> +               .init = hantro_mpeg2_dec_init,
>> +               .exit = hantro_mpeg2_dec_exit,
>> +       },
>> +       [HANTRO_MODE_VP8_DEC] = {
>> +               .run = hantro_g1_vp8_dec_run,
>> +               .reset = rk3066_vpu_dec_reset,
>> +               .init = hantro_vp8_dec_init,
>> +               .exit = hantro_vp8_dec_exit,
>> +       },
>> +};
>>   
>>   static const struct hantro_codec_ops rk3288_vpu_codec_ops[] = {
>>          [HANTRO_MODE_JPEG_ENC] = {
>> @@ -183,10 +274,35 @@ static const struct hantro_irq rk3288_irqs[] = {
>>          { "vdpu", hantro_g1_irq },
>>   };
>>   
>> +static const char * const rk3066_clk_names[] = {
>> +       "aclk_vdpu", "hclk_vdpu",
>> +       "aclk_vepu", "hclk_vepu"
>> +};
>> +
>>   static const char * const rk3288_clk_names[] = {
>>          "aclk", "hclk"
>>   };
>>   
>> +const struct hantro_variant rk3066_vpu_variant = {
>> +       .enc_offset = 0x0,
>> +       .enc_fmts = rk3288_vpu_enc_fmts,
>> +       .num_enc_fmts = ARRAY_SIZE(rk3288_vpu_enc_fmts),
>> +       .dec_offset = 0x400,
> Having decoder and encoder supported by a single devicetree
> node was done for RK3288 to cope with some bug in the hardware
> that was effectively linking the decoder and the encoder.
>
> AFAIK, Rockchip has fixed this, so unless there's a strong
> need, I prefer we keep them separated, with one DT node
> for the g1 decoder and one for the h1 encoder.
>
> Thanks!
> Ezequiel
>
I just checked it: despite it looks like we could use the decoder and 
encoder separately

(separate clocks for decoder / encoder) the VPU block won't work (SoC 
crashes),

if not all 4 clocks are enabled for neither decoding nor encoding.

I'd prefer the other way also, but it seems not possible.

Alex.




More information about the linux-arm-kernel mailing list