[PATCH v3 1/2] ARM: dts: da850-lego-ev3: align GPIO hog names with dt-schema

[Aswath Govindraju]

The GPIO hog dt-schema node naming convention expect GPIO hogs node names
to end with a 'hog' suffix.

Signed-off-by: Aswath Govindraju <a-govindraju at ti.com>
---
 arch/arm/boot/dts/da850-lego-ev3.dts | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/arch/arm/boot/dts/da850-lego-ev3.dts b/arch/arm/boot/dts/da850-lego-ev3.dts
index afd04a423856..1e86cde86406 100644
--- a/arch/arm/boot/dts/da850-lego-ev3.dts
+++ b/arch/arm/boot/dts/da850-lego-ev3.dts
@@ -412,14 +412,14 @@
 	status = "okay";
 
 	/* Don't pull down battery voltage adc io channel */
-	batt_volt_en {
+	batt-volt-en-hog {
 		gpio-hog;
 		gpios = <6 GPIO_ACTIVE_HIGH>;
 		output-high;
 	};
 
 	/* Don't impede Bluetooth clock signal */
-	bt_clock_en {
+	bt-clock-en-hog {
 		gpio-hog;
 		gpios = <5 GPIO_ACTIVE_HIGH>;
 		input;
@@ -433,19 +433,19 @@
 	 * anything, but they are present in the source code from LEGO.
 	 */
 
-	bt_pic_en {
+	bt-pic-en-hog {
 		gpio-hog;
 		gpios = <51 GPIO_ACTIVE_HIGH>;
 		output-low;
 	};
 
-	bt_pic_rst {
+	bt-pic-rst-hog {
 		gpio-hog;
 		gpios = <78 GPIO_ACTIVE_HIGH>;
 		output-high;
 	};
 
-	bt_pic_cts {
+	bt-pic-cts-hog {
 		gpio-hog;
 		gpios = <87 GPIO_ACTIVE_HIGH>;
 		input;
-- 
2.17.1