[PATCH] serial: 8250: 8250_omap: Fix possible interrupt storm

[Vignesh Raghavendra]

It is possible that RX TIMEOUT is signalled after RX FIFO has been
drained, in which case a dummy read of RX FIFO is required to clear RX
TIMEOUT condition. Otherwise, RX TIMEOUT condition is not cleared
leading to an interrupt storm

Cc: stable at vger.kernel.org
Reported-by: Jan Kiszka <jan.kiszka at siemens.com>
Signed-off-by: Vignesh Raghavendra <vigneshr at ti.com>
---
 drivers/tty/serial/8250/8250_omap.c | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/drivers/tty/serial/8250/8250_omap.c b/drivers/tty/serial/8250/8250_omap.c
index 8ac11eaeca51..c71bd766fa56 100644
--- a/drivers/tty/serial/8250/8250_omap.c
+++ b/drivers/tty/serial/8250/8250_omap.c
@@ -104,6 +104,9 @@
 #define UART_OMAP_EFR2			0x23
 #define UART_OMAP_EFR2_TIMEOUT_BEHAVE	BIT(6)
 
+/* RX FIFO occupancy indicator */
+#define UART_OMAP_RX_LVL		0x64
+
 struct omap8250_priv {
 	int line;
 	u8 habit;
@@ -625,6 +628,15 @@ static irqreturn_t omap8250_irq(int irq, void *dev_id)
 	serial8250_rpm_get(up);
 	iir = serial_port_in(port, UART_IIR);
 	ret = serial8250_handle_irq(port, iir);
+	/*
+	 * It is possible that RX TIMEOUT is signalled after FIFO
+	 * has been drained, in which case a dummy read of RX FIFO is
+	 * required to clear RX TIMEOUT condition.
+	 */
+	if ((iir & UART_IIR_RX_TIMEOUT) == UART_IIR_RX_TIMEOUT) {
+		if (serial_port_in(port, UART_OMAP_RX_LVL) == 0)
+			serial_port_in(port, UART_RX);
+	}
 	serial8250_rpm_put(up);
 
 	return IRQ_RETVAL(ret);
-- 
2.31.1