[PATCH V2 3/4] ARM: dts: stm32: Update GPIO line names on DRC02

[Marek Vasut]

Use more specific custom GPIO line names which denote exactly where
the GPIO came from, i.e. the base board. Also, update the new blank
GPIO line names set up by stm32mp15xx-dhcom-som.dtsi back to their
original values.

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Alexandre Torgue <alexandre.torgue at foss.st.com>
Cc: Patrice Chotard <patrice.chotard at foss.st.com>
Cc: Patrick Delaunay <patrick.delaunay at foss.st.com>
Cc: linux-stm32 at st-md-mailman.stormreply.com
To: linux-arm-kernel at lists.infradead.org
---
V2: New patch
---
 arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi | 12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)

diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
index fad23d6f69b8..fb45c5aa878d 100644
--- a/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
+++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
@@ -43,15 +43,15 @@ rs485-rx-en-hog {
 
 &gpiod {
 	gpio-line-names = "", "", "", "",
-			  "", "", "", "",
-			  "", "", "", "Out1",
-			  "Out2", "", "", "";
+			  "", "", "DHCOM-B", "",
+			  "", "", "", "DRC02-Out1",
+			  "DRC02-Out2", "", "", "";
 };
 
 &gpioi {
-	gpio-line-names = "In1", "", "", "",
-			  "", "", "", "",
-			  "In2", "", "", "",
+	gpio-line-names = "DRC02-In1", "DHCOM-O", "DHCOM-H", "DHCOM-I",
+			  "DHCOM-R", "DHCOM-M", "", "",
+			  "DRC02-In2", "", "", "",
 			  "", "", "", "";
 
 	/*
-- 
2.30.2