[PATCH 3/3] net: dsa: mt7530: setup core clock even in TRGMII mode

Ilya Lipnitskiy ilya.lipnitskiy at gmail.com
Thu Mar 11 02:39:29 GMT 2021


Hi Vladimir,

On Wed, Mar 10, 2021 at 3:10 PM Vladimir Oltean <olteanv at gmail.com> wrote:
>
> Hello Ilya,
>
> On Wed, Mar 10, 2021 at 01:14:20PM -0800, Ilya Lipnitskiy wrote:
> > 3f9ef7785a9c ("MIPS: ralink: manage low reset lines") made it so mt7530
> > actually resets the switch on platforms such as mt7621 (where bit 2 is
> > the reset line for the switch). That exposed an issue where the switch
> > would not function properly in TRGMII mode after a reset.
> >
> > Reconfigure core clock in TRGMII mode to fix the issue.
> >
> > Also, disable both core and TRGMII Tx clocks prior to reconfiguring.
> > Previously, only the core clock was disabled, but not TRGMII Tx clock.
> >
> > Tested on Ubiquity ER-X (MT7621) with TRGMII mode enabled.
> >
> > Signed-off-by: Ilya Lipnitskiy <ilya.lipnitskiy at gmail.com>
> > ---
>
> For the networking subsystem there are two git trees, "net" for bugfixes
> and "net-next" for new features, and we specify the target tree using
> git send-email --subject-prefix="PATCH net-next".
>
> I assume you would like the v5.12 kernel to actually be functional on
> the Ubiquiti ER-X switch, so I would recommend keeping this patch
> minimal and splitting it out from the current series, and targeting it
> towards the "net" tree, which will eventually get merged into one of the
> v5.12 rc's and then into the final version. The other patches won't go
> into v5.12 but into v5.13, hence the "next" name.
I think I knew this, but didn't think it through. Thanks for your
guidance. I have submitted a single patch to "net" and that same patch
and two more to "net-next" - hopefully that looks better, but I'm sure
I have more to learn still.

>
> Also add these lines in your .gitconfig:
>
> [core]
>         abbrev = 12
> [pretty]
>         fixes = Fixes: %h (\"%s\")
>
> and run:
>
> git show 3f9ef7785a9c --pretty=fixes
> Fixes: 3f9ef7785a9c ("MIPS: ralink: manage low reset lines")
>
> and paste that "Fixes:" line in the commit message, right above your
> Signed-off-by: tag.



More information about the linux-arm-kernel mailing list