[PATCH V2 01/15] ARM: dts: imx6q-dhcom: Add the parallel system bus

[Marek Vasut]

On 6/22/21 11:59 AM, Christoph Niedermaier wrote:
> Add the parallel system bus provided by the i.MX6 WEIM interface via an
> address latch. The OE pin of the latch is controlled by a fixed regulator.
> The pin is low active. This is ensured by omitting the regulators property
> enable-active-high. The flags value of the gpio property (3rd value), which
> is also use to define active high/low, is set to 0 because it is ignored
> by gpiolib-of.c.
> 
> Signed-off-by: Christoph Niedermaier <cniedermaier at dh-electronics.com>
> Cc: Shawn Guo <shawnguo at kernel.org>
> Cc: Fabio Estevam <festevam at gmail.com>
> Cc: Marek Vasut <marex at denx.de>
> Cc: NXP Linux Team <linux-imx at nxp.com>
> Cc: kernel at dh-electronics.com
> To: linux-arm-kernel at lists.infradead.org

Reviewed-by: Marek Vasut <marex at denx.de>