[PATCH 7/7] mmc: arasan: Fix the issue in reading tap values from DT

[Manish Narani]

From: Sai Krishna Potthuri <lakshmi.sai.krishna.potthuri at xilinx.com>

'of_property_read_variable_u32_array' function returns number
of elements read on success. This patch updates the condition
check in the driver to overwrite the tap values from DT if exist.

Signed-off-by: Sai Krishna Potthuri <lakshmi.sai.krishna.potthuri at xilinx.com>
Signed-off-by: Manish Narani <manish.narani at xilinx.com>
---
 drivers/mmc/host/sdhci-of-arasan.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/mmc/host/sdhci-of-arasan.c b/drivers/mmc/host/sdhci-of-arasan.c
index 61fe13c..3f50095 100644
--- a/drivers/mmc/host/sdhci-of-arasan.c
+++ b/drivers/mmc/host/sdhci-of-arasan.c
@@ -1019,13 +1019,15 @@ static void arasan_dt_read_clk_phase(struct device *dev,
 	struct device_node *np = dev->of_node;
 
 	u32 clk_phase[2] = {0};
+	int ret;
 
 	/*
 	 * Read Tap Delay values from DT, if the DT does not contain the
 	 * Tap Values then use the pre-defined values.
 	 */
-	if (of_property_read_variable_u32_array(np, prop, &clk_phase[0],
-						2, 0)) {
+	ret = of_property_read_variable_u32_array(np, prop, &clk_phase[0],
+						  2, 0);
+	if (ret < 0) {
 		dev_dbg(dev, "Using predefined clock phase for %s = %d %d\n",
 			prop, clk_data->clk_phase_in[timing],
 			clk_data->clk_phase_out[timing]);
-- 
2.1.1