[PATCH] arm64/mm: Fix ttbr0 values stored in struct thread_info for software-pan

[Will Deacon]

On Tue, Jun 15, 2021 at 03:25:39PM +0100, Catalin Marinas wrote:
> On Tue, Jun 15, 2021 at 03:02:58PM +0530, Anshuman Khandual wrote:
> > When using CONFIG_ARM64_SW_TTBR0_PAN, a task's thread_info::ttbr0 must be
> > the TTBR0_EL1 value used to run userspace. With 52-bit PAs, the PA must be
> > packed into the TTBR using phys_to_ttbr(), but we forget to do this in some
> > of the SW PAN code. Thus, if the value is installed into TTBR0_EL1 (as may
> > happen in the uaccess routines), this could result in UNPREDICTABLE
> > behaviour.
> > 
> > Since hardware with 52-bit PA support almost certainly has HW PAN, which
> > will be used in preference, this shouldn't be a practical issue, but let's
> > fix this for consistency.
> 
> I'm ok with fixing this for consistency. We should never hit those paths
> unless someone built hardware with 52-bit PA (8.2) but without PAN (8.1)
> and it would not be architecture compliant.
> 
> I'll leave it with Will for 5.14, it's no a fix that needs urgent
> queuing.
> 
> Reviewed-by: Catalin Marinas <catalin.marinas at arm.com>

Cheers, I'll pick it up.

Will