[PATCH v1 4/7] ARM: dts: imx6dl-prtvt7: add TSC2046 touchscreen node

[robin]

On 2021-01-20 15:22, Oleksij Rempel wrote:
> Add touchscreen support to the Protonic VT7 board.
> 
> Co-Developed-by: Robin van der Gracht <robin at protonic.nl>
> Signed-off-by: Robin van der Gracht <robin at protonic.nl>
> Signed-off-by: Oleksij Rempel <o.rempel at pengutronix.de>
> ---
>  arch/arm/boot/dts/imx6dl-prtvt7.dts | 20 ++++++++++++++++++++
>  1 file changed, 20 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/imx6dl-prtvt7.dts
> b/arch/arm/boot/dts/imx6dl-prtvt7.dts
> index d9cb1e41cc10..63ae2065834c 100644
> --- a/arch/arm/boot/dts/imx6dl-prtvt7.dts
> +++ b/arch/arm/boot/dts/imx6dl-prtvt7.dts
> @@ -266,6 +266,26 @@ &ecspi2 {
>  	pinctrl-names = "default";
>  	pinctrl-0 = <&pinctrl_ecspi2>;
>  	status = "okay";
> +
> +	touchscreen at 0 {
> +		compatible = "ti,tsc2046";
> +		reg = <0>;
> +		pinctrl-0 = <&pinctrl_tsc>;
> +		pinctrl-names ="default";
> +		spi-max-frequency = <100000>;
> +		interrupts-extended = <&gpio3 20 IRQ_TYPE_EDGE_FALLING>;
> +		pendown-gpio = <&gpio3 20 GPIO_ACTIVE_LOW>;
> +
> +		touchscreen-inverted-x;
> +		touchscreen-inverted-y;

Please remove both inverted properties since it's not inverted.

> +		touchscreen-max-pressure = <4095>;
> +
> +		ti,vref-delay-usecs = /bits/ 16 <100>;
> +		ti,x-plate-ohms = /bits/ 16 <800>;
> +		ti,y-plate-ohms = /bits/ 16 <300>;
> +
> +		wakeup-source;
> +	};
>  };
> 
>  &i2c1 {

Robin