[PATCH] ARM: dts: stm32: Fix GPIO hog names on DHCOM

[Alexandre TORGUE]

Hi Marek

On 12/24/20 7:24 AM, Marek Vasut wrote:
> The GPIO hog node name should match regex '^(hog-[0-9]+|.+-hog(-[0-9]+)?)$',
> make it so and fix the following two make dtbs_check warnings:
> 
> arch/arm/boot/dts/stm32mp157c-dhcom-picoitx.dt.yaml: hog-usb-port-power: $nodename:0: 'hog-usb-port-power' does not match '^(hog-[0-9]+|.+-hog(-[0-9]+)?)$'
> arch/arm/boot/dts/stm32mp153c-dhcom-drc02.dt.yaml: hog-usb-hub: $nodename:0: 'hog-usb-hub' does not match '^(hog-[0-9]+|.+-hog(-[0-9]+)?)$'
> 
> Signed-off-by: Marek Vasut <marex at denx.de>
> Cc: Alexandre Torgue <alexandre.torgue at st.com>
> Cc: Maxime Coquelin <mcoquelin.stm32 at gmail.com>
> Cc: Patrice Chotard <patrice.chotard at st.com>
> Cc: Patrick Delaunay <patrick.delaunay at st.com>
> Cc: linux-stm32 at st-md-mailman.stormreply.com
> To: linux-arm-kernel at lists.infradead.org
> ---
>   arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi   | 4 ++--
>   arch/arm/boot/dts/stm32mp15xx-dhcom-picoitx.dtsi | 2 +-
>   2 files changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
> index 62ab23824a3e..cb68afbbea68 100644
> --- a/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
> +++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
> @@ -33,7 +33,7 @@ &gpiob {
>   	 * during TX anyway and that it only controls drive enable DE
>   	 * line. Hence, the RX is always enabled here.
>   	 */
> -	rs485-rx-en {
> +	rs485-rx-en-hog {
>   		gpio-hog;
>   		gpios = <8 GPIO_ACTIVE_HIGH>;
>   		output-low;
> @@ -61,7 +61,7 @@ &gpioi {
>   	 * order to reset the Hub when USB bus is powered down, but
>   	 * so far there is no such functionality.
>   	 */
> -	usb-hub {
> +	usb-hub-hog {
>   		gpio-hog;
>   		gpios = <2 GPIO_ACTIVE_HIGH>;
>   		output-high;
> diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-picoitx.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-picoitx.dtsi
> index 356150d28c42..b99f2b891629 100644
> --- a/arch/arm/boot/dts/stm32mp15xx-dhcom-picoitx.dtsi
> +++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-picoitx.dtsi
> @@ -43,7 +43,7 @@ &gpioa {
>   	 * in order to turn on port power when USB bus is powered up, but so
>   	 * far there is no such functionality.
>   	 */
> -	usb-port-power {
> +	usb-port-power-hog {
>   		gpio-hog;
>   		gpios = <13 GPIO_ACTIVE_LOW>;
>   		output-low;
> 

Applied on stm32-fixes with a Fixes tag added.

Thanks.
Alex