[PATCH] arm64: dts: rockchip: rename pinctrl nodename to gmac2io for nanopi-r2s board

Chen-Yu Tsai wens at kernel.org
Sun Jan 10 22:50:05 EST 2021


Hi Rob,

On Mon, Jan 11, 2021 at 3:50 AM Johan Jonker <jbx6244 at gmail.com> wrote:
>
> A test with the command below gives this error:
> /arch/arm64/boot/dts/rockchip/rk3328-nanopi-r2s.dt.yaml:
> ethernet-phy: 'reg' is a required property
>
> The pinctrl nodename "ethernet-phy" conflicts with the rules
> in the "ethernet-phy.yaml" document, so rename it to "gmac2io".

This seems more like an unintended side effect of the ethernet-phy binding.
Is there a way to limit the matching of the binding only if the parent is an
"mdio" or "ethernet" node? Would that make more sense?


Regards
ChenYu

> make ARCH=arm64 dtbs_check
> DT_SCHEMA_FILES=Documentation/devicetree/bindings/net/ethernet-phy.yaml
>
> Signed-off-by: Johan Jonker <jbx6244 at gmail.com>
> ---
>  arch/arm64/boot/dts/rockchip/rk3328-nanopi-r2s.dts | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/rockchip/rk3328-nanopi-r2s.dts b/arch/arm64/boot/dts/rockchip/rk3328-nanopi-r2s.dts
> index 2ee07d15a..86732b45d 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3328-nanopi-r2s.dts
> +++ b/arch/arm64/boot/dts/rockchip/rk3328-nanopi-r2s.dts
> @@ -280,7 +280,7 @@
>                 };
>         };
>
> -       ethernet-phy {
> +       gmac2io {
>                 eth_phy_reset_pin: eth-phy-reset-pin {
>                         rockchip,pins = <1 RK_PC2 RK_FUNC_GPIO &pcfg_pull_down>;
>                 };
> --
> 2.11.0
>
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel



More information about the linux-arm-kernel mailing list