[PATCH v13 net-next 14/15] net: mvpp2: set 802.3x GoP Flow Control mode

[Russell King - ARM Linux admin]

On Thu, Feb 11, 2021 at 12:49:01PM +0200, stefanc at marvell.com wrote:
> From: Stefan Chulski <stefanc at marvell.com>
> 
> This patch fix GMAC TX flow control autoneg.
> Flow control autoneg wrongly were disabled with enabled TX
> flow control.
> 
> Signed-off-by: Stefan Chulski <stefanc at marvell.com>
> Acked-by: Marcin Wojtas <mw at semihalf.com>

Should this patch be placed towards the start of this series (along with
the other fix for the thread number limit I mentioned previously?)

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!