[PATCH V2] drivers: net: ethernet: i825xx: Fix couple of spellings and get rid of blank lines too in the file ether1.c

[Bhaskar Chowdhury]

s/initialsation/initialisation/
s/specifiing/specifying/

Plus get rid of few blank lines.

Signed-off-by: Bhaskar Chowdhury <unixbhaskar at gmail.com>
---
Changes from V1:
   Fix typo in the subject line
   Give explanation of all the changes in changelog text

 drivers/net/ethernet/i825xx/ether1.c | 9 +++------
 1 file changed, 3 insertions(+), 6 deletions(-)

diff --git a/drivers/net/ethernet/i825xx/ether1.c b/drivers/net/ethernet/i825xx/ether1.c
index a0bfb509e002..850ea32091ed 100644
--- a/drivers/net/ethernet/i825xx/ether1.c
+++ b/drivers/net/ethernet/i825xx/ether1.c
@@ -20,7 +20,7 @@
  * 1.02	RMK	25/05/1997	Added code to restart RU if it goes not ready
  * 1.03	RMK	14/09/1997	Cleaned up the handling of a reset during the TX interrupt.
  *				Should prevent lockup.
- * 1.04 RMK	17/09/1997	Added more info when initialsation of chip goes wrong.
+ * 1.04 RMK	17/09/1997	Added more info when initialisation of chip goes wrong.
  *				TDR now only reports failure when chip reports non-zero
  *				TDR time-distance.
  * 1.05	RMK	31/12/1997	Removed calls to dev_tint for 2.1
@@ -117,7 +117,7 @@ ether1_outw_p (struct net_device *dev, unsigned short val, int addr, int svflgs)
  * Some inline assembler to allow fast transfers on to/off of the card.
  * Since this driver depends on some features presented by the ARM
  * specific architecture, and that you can't configure this driver
- * without specifiing ARM mode, this is not a problem.
+ * without specifying ARM mode, this is not a problem.
  *
  * This routine is essentially an optimised memcpy from the card's
  * onboard RAM to kernel memory.
@@ -885,7 +885,6 @@ ether1_recv_done (struct net_device *dev)
 		ether1_writew(dev, 0, priv(dev)->rx_tail, rfd_t, rfd_command, NORMALIRQS);
 		ether1_writew(dev, 0, priv(dev)->rx_tail, rfd_t, rfd_status, NORMALIRQS);
 		ether1_writew(dev, 0, priv(dev)->rx_tail, rfd_t, rfd_rbdoffset, NORMALIRQS);
-
 		priv(dev)->rx_tail = nexttail;
 		priv(dev)->rx_head = ether1_readw(dev, priv(dev)->rx_head, rfd_t, rfd_link, NORMALIRQS);
 	} while (1);
@@ -1028,10 +1027,8 @@ ether1_probe(struct expansion_card *ec, const struct ecard_id *id)
 	ret = register_netdev(dev);
 	if (ret)
 		goto free;
-
 	printk(KERN_INFO "%s: ether1 in slot %d, %pM\n",
 		dev->name, ec->slot_no, dev->dev_addr);
-
 	ecard_set_drvdata(ec, dev);
 	return 0;

@@ -1047,7 +1044,7 @@ static void ether1_remove(struct expansion_card *ec)
 {
 	struct net_device *dev = ecard_get_drvdata(ec);

-	ecard_set_drvdata(ec, NULL);
+	ecard_set_drvdata(ec, NULL);

 	unregister_netdev(dev);
 	free_netdev(dev);
--
2.26.2