[PATCH v2 4/6] iommu/dma: Pass address limit rather than size to iommu_setup_dma_ops()

Jean-Philippe Brucker jean-philippe at linaro.org
Fri Apr 23 12:38:35 BST 2021


Passing a 64-bit address width to iommu_setup_dma_ops() is valid on
virtual platforms, but isn't currently possible. The overflow check in
iommu_dma_init_domain() prevents this even when @dma_base isn't 0. Pass
a limit address instead of a size, so callers don't have to fake a size
to work around the check.

Signed-off-by: Jean-Philippe Brucker <jean-philippe at linaro.org>
---
 include/linux/dma-iommu.h   |  4 ++--
 arch/arm64/mm/dma-mapping.c |  2 +-
 drivers/iommu/amd/iommu.c   |  2 +-
 drivers/iommu/dma-iommu.c   | 12 ++++++------
 drivers/iommu/intel/iommu.c |  2 +-
 5 files changed, 11 insertions(+), 11 deletions(-)

diff --git a/include/linux/dma-iommu.h b/include/linux/dma-iommu.h
index 6e75a2d689b4..758ca4694257 100644
--- a/include/linux/dma-iommu.h
+++ b/include/linux/dma-iommu.h
@@ -19,7 +19,7 @@ int iommu_get_msi_cookie(struct iommu_domain *domain, dma_addr_t base);
 void iommu_put_dma_cookie(struct iommu_domain *domain);
 
 /* Setup call for arch DMA mapping code */
-void iommu_setup_dma_ops(struct device *dev, u64 dma_base, u64 size);
+void iommu_setup_dma_ops(struct device *dev, u64 dma_base, u64 dma_limit);
 
 /* The DMA API isn't _quite_ the whole story, though... */
 /*
@@ -50,7 +50,7 @@ struct msi_msg;
 struct device;
 
 static inline void iommu_setup_dma_ops(struct device *dev, u64 dma_base,
-		u64 size)
+				       u64 dma_limit)
 {
 }
 
diff --git a/arch/arm64/mm/dma-mapping.c b/arch/arm64/mm/dma-mapping.c
index 93e87b287556..83f4f4bad5e4 100644
--- a/arch/arm64/mm/dma-mapping.c
+++ b/arch/arm64/mm/dma-mapping.c
@@ -50,7 +50,7 @@ void arch_setup_dma_ops(struct device *dev, u64 dma_base, u64 size,
 
 	dev->dma_coherent = coherent;
 	if (iommu)
-		iommu_setup_dma_ops(dev, dma_base, size);
+		iommu_setup_dma_ops(dev, dma_base, size - dma_base - 1);
 
 #ifdef CONFIG_XEN
 	if (xen_initial_domain())
diff --git a/drivers/iommu/amd/iommu.c b/drivers/iommu/amd/iommu.c
index 67da96d5b3c2..50041df43391 100644
--- a/drivers/iommu/amd/iommu.c
+++ b/drivers/iommu/amd/iommu.c
@@ -1713,7 +1713,7 @@ static void amd_iommu_probe_finalize(struct device *dev)
 	/* Domains are initialized for this device - have a look what we ended up with */
 	domain = iommu_get_domain_for_dev(dev);
 	if (domain->type == IOMMU_DOMAIN_DMA)
-		iommu_setup_dma_ops(dev, IOVA_START_PFN << PAGE_SHIFT, 0);
+		iommu_setup_dma_ops(dev, IOVA_START_PFN << PAGE_SHIFT, U64_MAX);
 	else
 		set_dma_ops(dev, NULL);
 }
diff --git a/drivers/iommu/dma-iommu.c b/drivers/iommu/dma-iommu.c
index 7bcdd1205535..c62e19bed302 100644
--- a/drivers/iommu/dma-iommu.c
+++ b/drivers/iommu/dma-iommu.c
@@ -319,16 +319,16 @@ static bool dev_is_untrusted(struct device *dev)
  * iommu_dma_init_domain - Initialise a DMA mapping domain
  * @domain: IOMMU domain previously prepared by iommu_get_dma_cookie()
  * @base: IOVA at which the mappable address space starts
- * @size: Size of IOVA space
+ * @limit: Last address of the IOVA space
  * @dev: Device the domain is being initialised for
  *
- * @base and @size should be exact multiples of IOMMU page granularity to
+ * @base and @limit + 1 should be exact multiples of IOMMU page granularity to
  * avoid rounding surprises. If necessary, we reserve the page at address 0
  * to ensure it is an invalid IOVA. It is safe to reinitialise a domain, but
  * any change which could make prior IOVAs invalid will fail.
  */
 static int iommu_dma_init_domain(struct iommu_domain *domain, dma_addr_t base,
-		u64 size, struct device *dev)
+				 dma_addr_t limit, struct device *dev)
 {
 	struct iommu_dma_cookie *cookie = domain->iova_cookie;
 	unsigned long order, base_pfn;
@@ -346,7 +346,7 @@ static int iommu_dma_init_domain(struct iommu_domain *domain, dma_addr_t base,
 	/* Check the domain allows at least some access to the device... */
 	if (domain->geometry.force_aperture) {
 		if (base > domain->geometry.aperture_end ||
-		    base + size <= domain->geometry.aperture_start) {
+		    limit < domain->geometry.aperture_start) {
 			pr_warn("specified DMA range outside IOMMU capability\n");
 			return -EFAULT;
 		}
@@ -1308,7 +1308,7 @@ static const struct dma_map_ops iommu_dma_ops = {
  * The IOMMU core code allocates the default DMA domain, which the underlying
  * IOMMU driver needs to support via the dma-iommu layer.
  */
-void iommu_setup_dma_ops(struct device *dev, u64 dma_base, u64 size)
+void iommu_setup_dma_ops(struct device *dev, u64 dma_base, u64 dma_limit)
 {
 	struct iommu_domain *domain = iommu_get_domain_for_dev(dev);
 
@@ -1320,7 +1320,7 @@ void iommu_setup_dma_ops(struct device *dev, u64 dma_base, u64 size)
 	 * underlying IOMMU driver needs to support via the dma-iommu layer.
 	 */
 	if (domain->type == IOMMU_DOMAIN_DMA) {
-		if (iommu_dma_init_domain(domain, dma_base, size, dev))
+		if (iommu_dma_init_domain(domain, dma_base, dma_limit, dev))
 			goto out_err;
 		dev->dma_ops = &iommu_dma_ops;
 	}
diff --git a/drivers/iommu/intel/iommu.c b/drivers/iommu/intel/iommu.c
index 708f430af1c4..39a4e672b1c2 100644
--- a/drivers/iommu/intel/iommu.c
+++ b/drivers/iommu/intel/iommu.c
@@ -5166,7 +5166,7 @@ static void intel_iommu_probe_finalize(struct device *dev)
 
 	if (domain && domain->type == IOMMU_DOMAIN_DMA)
 		iommu_setup_dma_ops(dev, base,
-				    __DOMAIN_MAX_ADDR(dmar_domain->gaw) - base);
+				    __DOMAIN_MAX_ADDR(dmar_domain->gaw));
 	else
 		set_dma_ops(dev, NULL);
 }
-- 
2.31.1




More information about the linux-arm-kernel mailing list