[PATCH v4 1/2] pinctrl: single: parse #pinctrl-cells = 2

[Trent Piepho]

On Tuesday, June 30, 2020 6:33:19 PM PDT Drew Fustini wrote:
> If "pinctrl-single,pins" has 3 arguments (offset, conf, mux), then
> pcs_parse_one_pinctrl_entry() does an OR operation on conf and mux to
> get the value to store in the register.


> -		vals[found].val = pinctrl_spec.args[1];
> +
> +		switch (pinctrl_spec.args_count) {
> +		case 2:
> +			vals[found].val = pinctrl_spec.args[1];
> +			break;
> +		case 3:
> +			vals[found].val = (pinctrl_spec.args[1] | 
pinctrl_spec.args[2]);
> +			break;
> +		}
> 
>  		dev_dbg(pcs->dev, "%pOFn index: 0x%x value: 0x%x\n",
>  			pinctrl_spec.np, offset, 
pinctrl_spec.args[1]);

If #pinctrl-cells value is greater than 2, nothing will set vals[found].val to 
anything other than zero (from when it's calloc'ed) and the pinctrl will 
silently be programmed to zero.

The debug printout was not change to print vals[found].val, so it will 
continue to print the value of the 2nd cell.

The result is that a #pinctrl-cells of 3 will produce no warning or error, 
program the pinctrl to zero, whilst at the same time emit debug log messages 
that it is programming the expected values.

The device tree documentation still states that #pinctrl-cells must be 1 when 
using pinctrl-single,pins.  This new special case of ORing two values is not 
documented.