[PATCH 1/2] thermal: ti-soc-thermal: Enable addition power management

[Daniel Lezcano]

On 11/09/2020 14:31, Adam Ford wrote:
> The bandgap sensor can be idled when the processor is too, but it
> isn't currently being done, so the power consumption of OMAP3
> boards can elevated if the bangap sensor is enabled.
> 
> This patch attempts to use some additional power management
> to idle the clock to the bandgap when not needed.
> 
> Signed-off-by: Adam Ford <aford173 at gmail.com>
> Reported-by: kernel test robot <lkp at intel.com>
> Tested-by: Andreas Kemnade <andreas at kemnade.info> # GTA04
> ---

[ ... ]

> -	/* First thing is to remove sensor interfaces */
> +	cpu_pm_unregister_notifier(&bgp->nb);
> +
> +	/* Remove sensor interfaces */
>  	for (i = 0; i < bgp->conf->sensor_count; i++) {
>  		if (bgp->conf->sensors[i].unregister_cooling)
>  			bgp->conf->sensors[i].unregister_cooling(bgp, i);
> @@ -1150,9 +1167,43 @@ static int ti_bandgap_suspend(struct device *dev)
>  	if (TI_BANDGAP_HAS(bgp, CLK_CTRL))
>  		clk_disable_unprepare(bgp->fclock);
>  
> +	bgp->is_suspended = true;

Is this flag really needed?




-- 
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog