[RESEND PATCH 17/19] mmc: sunxi: add support for A100 mmc controller

André Przywara andre.przywara at arm.com
Sat Nov 28 14:56:34 EST 2020


On 10/11/2020 06:46, Frank Lee wrote:

Hi,

> From: Yangtao Li <frank at allwinnertech.com>
> 
> This patch adds support for A100 MMC controller, which use word address
> for internal dma.
> 
> Signed-off-by: Yangtao Li <frank at allwinnertech.com>
> ---
>  drivers/mmc/host/sunxi-mmc.c | 28 +++++++++++++++++++++++++---
>  1 file changed, 25 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/mmc/host/sunxi-mmc.c b/drivers/mmc/host/sunxi-mmc.c
> index fc62773602ec..1518b64112b7 100644
> --- a/drivers/mmc/host/sunxi-mmc.c
> +++ b/drivers/mmc/host/sunxi-mmc.c
> @@ -244,6 +244,7 @@ struct sunxi_idma_des {
>  
>  struct sunxi_mmc_cfg {
>  	u32 idma_des_size_bits;
> +	u32 idma_des_shift;
>  	const struct sunxi_mmc_clk_delay *clk_delays;
>  
>  	/* does the IP block support autocalibration? */
> @@ -343,7 +344,7 @@ static int sunxi_mmc_init_host(struct sunxi_mmc_host *host)
>  	/* Enable CEATA support */
>  	mmc_writel(host, REG_FUNS, SDXC_CEATA_ON);
>  	/* Set DMA descriptor list base address */
> -	mmc_writel(host, REG_DLBA, host->sg_dma);
> +	mmc_writel(host, REG_DLBA, host->sg_dma >> host->cfg->idma_des_shift);
>  
>  	rval = mmc_readl(host, REG_GCTRL);
>  	rval |= SDXC_INTERRUPT_ENABLE_BIT;
> @@ -373,8 +374,10 @@ static void sunxi_mmc_init_idma_des(struct sunxi_mmc_host *host,
>  
>  		next_desc += sizeof(struct sunxi_idma_des);
>  		pdes[i].buf_addr_ptr1 =
> -			cpu_to_le32(sg_dma_address(&data->sg[i]));
> -		pdes[i].buf_addr_ptr2 = cpu_to_le32((u32)next_desc);
> +			cpu_to_le32(sg_dma_address(&data->sg[i]) >>
> +				    host->cfg->idma_des_shift);
> +		pdes[i].buf_addr_ptr2 = cpu_to_le32((u32)next_desc >>
> +						    host->cfg->idma_des_shift);

I think you should cast after the shift, otherwise you lose the ability
to run above 4 GB. This won't be a problem at the moment, since we still
use the default 32-bit DMA mask, but might bite us later.

Otherwise this patch looks fine, and works on the H616 as well.

Cheers,
Andre

>  	}
>  
>  	pdes[0].config |= cpu_to_le32(SDXC_IDMAC_DES0_FD);
> @@ -1178,6 +1181,23 @@ static const struct sunxi_mmc_cfg sun50i_a64_emmc_cfg = {
>  	.needs_new_timings = true,
>  };
>  
> +static const struct sunxi_mmc_cfg sun50i_a100_cfg = {
> +	.idma_des_size_bits = 16,
> +	.idma_des_shift = 2,
> +	.clk_delays = NULL,
> +	.can_calibrate = true,
> +	.mask_data0 = true,
> +	.needs_new_timings = true,
> +};
> +
> +static const struct sunxi_mmc_cfg sun50i_a100_emmc_cfg = {
> +	.idma_des_size_bits = 13,
> +	.idma_des_shift = 2,
> +	.clk_delays = NULL,
> +	.can_calibrate = true,
> +	.needs_new_timings = true,
> +};
> +
>  static const struct of_device_id sunxi_mmc_of_match[] = {
>  	{ .compatible = "allwinner,sun4i-a10-mmc", .data = &sun4i_a10_cfg },
>  	{ .compatible = "allwinner,sun5i-a13-mmc", .data = &sun5i_a13_cfg },
> @@ -1186,6 +1206,8 @@ static const struct of_device_id sunxi_mmc_of_match[] = {
>  	{ .compatible = "allwinner,sun9i-a80-mmc", .data = &sun9i_a80_cfg },
>  	{ .compatible = "allwinner,sun50i-a64-mmc", .data = &sun50i_a64_cfg },
>  	{ .compatible = "allwinner,sun50i-a64-emmc", .data = &sun50i_a64_emmc_cfg },
> +	{ .compatible = "allwinner,sun50i-a100-mmc", .data = &sun50i_a100_cfg },
> +	{ .compatible = "allwinner,sun50i-a100-emmc", .data = &sun50i_a100_emmc_cfg },
>  	{ /* sentinel */ }
>  };
>  MODULE_DEVICE_TABLE(of, sunxi_mmc_of_match);
> 




More information about the linux-arm-kernel mailing list