[PATCH v2 10/13] arc: use FLATMEM with freeing of unused memory map instead of DISCONTIGMEM
Vineet Gupta
vgupta at synopsys.com
Mon Nov 23 19:26:20 EST 2020
On 11/16/20 10:57 PM, Mike Rapoport wrote:
> On Tue, Nov 17, 2020 at 06:40:16AM +0000, Vineet Gupta wrote:
>> Hi Mike,
>>
>> On 11/1/20 9:04 AM, Mike Rapoport wrote:
>>> From: Mike Rapoport <rppt at linux.ibm.com>
>>>
>>> Currently ARC uses DISCONTIGMEM to cope with sparse physical memory address
>>> space on systems with 2 memory banks. While DISCONTIGMEM avoids wasting
>>> memory on unpopulated memory map, it adds both memory and CPU overhead
>>> relatively to FLATMEM. Moreover, DISCONTINGMEM is generally considered
>>> deprecated.
>>>
>>> The obvious replacement for DISCONTIGMEM would be SPARSEMEM, but it is also
>>> less efficient than FLATMEM in pfn_to_page() and page_to_pfn() conversions.
>>> Besides it requires tuning of SECTION_SIZE which is not trivial for
>>> possible ARC memory configuration.
>>>
>>> Since the memory map for both banks is always allocated from the "lowmem"
>>> bank, it is possible to use FLATMEM for two-bank configuration and simply
>>> free the unused hole in the memory map. All is required for that is to
>>> provide ARC-specific pfn_valid() that will take into account actual
>>> physical memory configuration and define HAVE_ARCH_PFN_VALID.
>>>
>>> The resulting kernel image configured with defconfig + HIGHMEM=y is
>>> smaller:
>>>
>>> $ size a/vmlinux b/vmlinux
>>> text data bss dec hex filename
>>> 4673503 1245456 279756 6198715 5e95bb a/vmlinux
>>> 4658706 1246864 279756 6185326 5e616e b/vmlinux
>>>
>>> $ ./scripts/bloat-o-meter a/vmlinux b/vmlinux
>>> add/remove: 28/30 grow/shrink: 42/399 up/down: 10986/-29025 (-18039)
>>> ...
>>> Total: Before=4709315, After=4691276, chg -0.38%
>>>
>>> Booting nSIM with haps_ns.dts results in the following memory usage
>>> reports:
>>>
>>> a:
>>> Memory: 1559104K/1572864K available (3531K kernel code, 595K rwdata, 752K rodata, 136K init, 275K bss, 13760K reserved, 0K cma-reserved, 1048576K highmem)
>>>
>>> b:
>>> Memory: 1559112K/1572864K available (3519K kernel code, 594K rwdata, 752K rodata, 136K init, 280K bss, 13752K reserved, 0K cma-reserved, 1048576K highmem)
>>>
>>> Signed-off-by: Mike Rapoport <rppt at linux.ibm.com>
To avoid any surprises later, I tested that highmem was actually working
on real hardware (HSDK-4xD dev platform) with modified hsdk.dts to
enable 2 GB of memory.
reg = <0x0 0x80000000 0x0 0x40000000 /* 1 GB low mem */
- 0x1 0x00000000 0x0 0x40000000>; /* 1 GB highmem PAE */
+ 0x0 0x00000000 0x0 0x40000000>; /* 1 GB highmem low phy mem*/
};
A simple malloc+memset program can allocate upto 1.98 GB of memory.
# cat /proc/meminfo | grep Mem
MemTotal: 2077984 kB
MemFree: 2047512 kB
MemAvailable: 2005712 kB
# /oom 1000 &
# malloc 1000 MB
# Done memset, sleeping for 20 secs
# cat /proc/meminfo | grep Mem
MemTotal: 2077984 kB
MemFree: 1163888 kB
MemAvailable: 1122088 kB
# /oom 980 &
# malloc 980 MB
# Done memset, sleeping for 20 secs
# cat /proc/meminfo | grep Mem
MemTotal: 2077984 kB
MemFree: 239096 kB
MemAvailable: 197296 kB
# Done free.
Done free.
So this is all hunky-dory. Thanks for working on this Mike and improving
things.
Acked-by: Vineet Gupta <vgupta at synopsys.com>
-Vineet
>>
>> Sorry this fell through the cracks. Do you have a branch I can checkout
>> and do a quick test.
>
> It's in mmotm and in my tree:
> https://git.kernel.org/pub/scm/linux/kernel/git/rppt/linux.git memory-models/rm-discontig/v0
>
>> Thx,
>> -Vineet
>>
>>> ---
>>> arch/arc/Kconfig | 3 ++-
>>> arch/arc/include/asm/page.h | 20 +++++++++++++++++---
>>> arch/arc/mm/init.c | 29 ++++++++++++++++++++++-------
>>> 3 files changed, 41 insertions(+), 11 deletions(-)
>>>
>>> diff --git a/arch/arc/Kconfig b/arch/arc/Kconfig
>>> index 0a89cc9def65..c874f8ab0341 100644
>>> --- a/arch/arc/Kconfig
>>> +++ b/arch/arc/Kconfig
>>> @@ -67,6 +67,7 @@ config GENERIC_CSUM
>>>
>>> config ARCH_DISCONTIGMEM_ENABLE
>>> def_bool n
>>> + depends on BROKEN
>>>
>>> config ARCH_FLATMEM_ENABLE
>>> def_bool y
>>> @@ -506,7 +507,7 @@ config LINUX_RAM_BASE
>>>
>>> config HIGHMEM
>>> bool "High Memory Support"
>>> - select ARCH_DISCONTIGMEM_ENABLE
>>> + select HAVE_ARCH_PFN_VALID
>>> help
>>> With ARC 2G:2G address split, only upper 2G is directly addressable by
>>> kernel. Enable this to potentially allow access to rest of 2G and PAE
>>> diff --git a/arch/arc/include/asm/page.h b/arch/arc/include/asm/page.h
>>> index b0dfed0f12be..23e41e890eda 100644
>>> --- a/arch/arc/include/asm/page.h
>>> +++ b/arch/arc/include/asm/page.h
>>> @@ -82,11 +82,25 @@ typedef pte_t * pgtable_t;
>>> */
>>> #define virt_to_pfn(kaddr) (__pa(kaddr) >> PAGE_SHIFT)
>>>
>>> -#define ARCH_PFN_OFFSET virt_to_pfn(CONFIG_LINUX_RAM_BASE)
>>> +/*
>>> + * When HIGHMEM is enabled we have holes in the memory map so we need
>>> + * pfn_valid() that takes into account the actual extents of the physical
>>> + * memory
>>> + */
>>> +#ifdef CONFIG_HIGHMEM
>>> +
>>> +extern unsigned long arch_pfn_offset;
>>> +#define ARCH_PFN_OFFSET arch_pfn_offset
>>> +
>>> +extern int pfn_valid(unsigned long pfn);
>>> +#define pfn_valid pfn_valid
>>>
>>> -#ifdef CONFIG_FLATMEM
>>> +#else /* CONFIG_HIGHMEM */
>>> +
>>> +#define ARCH_PFN_OFFSET virt_to_pfn(CONFIG_LINUX_RAM_BASE)
>>> #define pfn_valid(pfn) (((pfn) - ARCH_PFN_OFFSET) < max_mapnr)
>>> -#endif
>>> +
>>> +#endif /* CONFIG_HIGHMEM */
>>>
>>> /*
>>> * __pa, __va, virt_to_page (ALERT: deprecated, don't use them)
>>> diff --git a/arch/arc/mm/init.c b/arch/arc/mm/init.c
>>> index 3a35b82a718e..ce07e697916c 100644
>>> --- a/arch/arc/mm/init.c
>>> +++ b/arch/arc/mm/init.c
>>> @@ -28,6 +28,8 @@ static unsigned long low_mem_sz;
>>> static unsigned long min_high_pfn, max_high_pfn;
>>> static phys_addr_t high_mem_start;
>>> static phys_addr_t high_mem_sz;
>>> +unsigned long arch_pfn_offset;
>>> +EXPORT_SYMBOL(arch_pfn_offset);
>>> #endif
>>>
>>> #ifdef CONFIG_DISCONTIGMEM
>>> @@ -98,16 +100,11 @@ void __init setup_arch_memory(void)
>>> init_mm.brk = (unsigned long)_end;
>>>
>>> /* first page of system - kernel .vector starts here */
>>> - min_low_pfn = ARCH_PFN_OFFSET;
>>> + min_low_pfn = virt_to_pfn(CONFIG_LINUX_RAM_BASE);
>>>
>>> /* Last usable page of low mem */
>>> max_low_pfn = max_pfn = PFN_DOWN(low_mem_start + low_mem_sz);
>>>
>>> -#ifdef CONFIG_FLATMEM
>>> - /* pfn_valid() uses this */
>>> - max_mapnr = max_low_pfn - min_low_pfn;
>>> -#endif
>>> -
>>> /*------------- bootmem allocator setup -----------------------*/
>>>
>>> /*
>>> @@ -153,7 +150,9 @@ void __init setup_arch_memory(void)
>>> * DISCONTIGMEM in turns requires multiple nodes. node 0 above is
>>> * populated with normal memory zone while node 1 only has highmem
>>> */
>>> +#ifdef CONFIG_DISCONTIGMEM
>>> node_set_online(1);
>>> +#endif
>>>
>>> min_high_pfn = PFN_DOWN(high_mem_start);
>>> max_high_pfn = PFN_DOWN(high_mem_start + high_mem_sz);
>>> @@ -161,8 +160,15 @@ void __init setup_arch_memory(void)
>>> max_zone_pfn[ZONE_HIGHMEM] = min_low_pfn;
>>>
>>> high_memory = (void *)(min_high_pfn << PAGE_SHIFT);
>>> +
>>> + arch_pfn_offset = min(min_low_pfn, min_high_pfn);
>>> kmap_init();
>>> -#endif
>>> +
>>> +#else /* CONFIG_HIGHMEM */
>>> + /* pfn_valid() uses this when FLATMEM=y and HIGHMEM=n */
>>> + max_mapnr = max_low_pfn - min_low_pfn;
>>> +
>>> +#endif /* CONFIG_HIGHMEM */
>>>
>>> free_area_init(max_zone_pfn);
>>> }
>>> @@ -190,3 +196,12 @@ void __init mem_init(void)
>>> highmem_init();
>>> mem_init_print_info(NULL);
>>> }
>>> +
>>> +#ifdef CONFIG_HIGHMEM
>>> +int pfn_valid(unsigned long pfn)
>>> +{
>>> + return (pfn >= min_high_pfn && pfn <= max_high_pfn) ||
>>> + (pfn >= min_low_pfn && pfn <= max_low_pfn);
>>> +}
>>> +EXPORT_SYMBOL(pfn_valid);
>>> +#endif
>>
>
More information about the linux-arm-kernel
mailing list