[PATCH 0/8] Add R5F nodes on TI K3 AM65x and J721E SoCs

[Lokesh Vutla]

On 29/10/20 9:07 am, Suman Anna wrote:
> Hi Nishanth,
> 
> The TI K3 R5F remoteproc driver and bindings were merged into 5.10-rc1,
> and this series adds the follow-on base dt nodes for the R5F remote
> processors on TI K3 AM65x and J721E SoCs. Additional memory nodes were
> also added to boot these processors successfully on applicable TI K3
> AM65x and J721E EVM boards. The series uses previously accepted mailbox
> nodes.
> 
> The patches follow slightly different convention between AM65x and
> J721E. The reserved-memory nodes are added directly in the relevant
> board dts file for AM65x boards, while they are added in the common
> k3-j721e-som-p0.dtsi file for J721E SoCs following the similar addition
> of K3 C66x and C71x DSP nodes in 5.10-rc1.
> 
> Patches apply on top of your 5.10-rc1 based staging branch.
> 
> I have validated the IPC functionality using System Firmware v2020.04a
> and corresponding IPC example firmwares. 


Series looks good to me.

Reviewed-by: Lokesh Vutla <lokeshvutla at ti.com>

On a side note: any reason not to add R5f nodes for J7200?

Thanks and regards,
Lokesh