[PATCH v2 1/2] dt-bindings: fpga: xilinx-slave-serial: add optional INIT_B GPIO

[Moritz Fischer]

On Mon, Jun 22, 2020 at 03:37:22PM +0200, Luca Ceresoli wrote:
> The INIT_B is used by the 6 and 7 series to report the programming status,
> providing more control and information about programming errors.
> 
> Signed-off-by: Luca Ceresoli <luca at lucaceresoli.net>
> 
> ---
> 
> Changes in v2:
>  - rename init_b-gpios to init-b-gpios (Rob Herring suggested to not use '_'
>    in property names)
> ---
>  .../devicetree/bindings/fpga/xilinx-slave-serial.txt       | 7 ++++++-
>  1 file changed, 6 insertions(+), 1 deletion(-)
> 
> diff --git a/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt b/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt
> index 9f103f3872e8..5ef659c1394d 100644
> --- a/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt
> +++ b/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt
> @@ -16,6 +16,10 @@ Required properties:
>  - prog_b-gpios: config pin (referred to as PROGRAM_B in the manual)
>  - done-gpios: config status pin (referred to as DONE in the manual)
>  
> +Optional properties:
> +- init-b-gpios: initialization status and configuration error pin
> +                (referred to as INIT_B in the manual)
> +
>  Example for full FPGA configuration:
>  
>  	fpga-region0 {
> @@ -40,7 +44,8 @@ Example for full FPGA configuration:
>  			spi-max-frequency = <60000000>;
>  			spi-cpha;
>  			reg = <0>;
> -			done-gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
>  			prog_b-gpios = <&gpio0 29 GPIO_ACTIVE_LOW>;
> +			init-b-gpios = <&gpio0 28 GPIO_ACTIVE_LOW>;
> +			done-gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
>  		};
>  	};
> -- 
> 2.27.0
> 

Will apply to for-next,

Thanks!