[PATCH v4 4/5] irqchip/irq-pruss-intc: Implement irq_{get,set}_irqchip_state ops

[David Lechner]

On 7/28/20 4:18 AM, Grzegorz Jaszczyk wrote:
> From: David Lechner <david at lechnology.com>
> 
> This implements the irq_get_irqchip_state and irq_set_irqchip_state
> callbacks for the TI PRUSS INTC driver. The set callback can be used
> by drivers to "kick" a PRU by injecting a PRU system event.
> 
> Example:

We could improve this example by showing a device tree node of a
firmware-defined device implemented in the PRU:

	/* Software-defined UART in PRU */
	pru_uart: serial at XXXX {
		compatible = "ti,pru-uart";
		...
		interrupt-parent = <&pruss_intc>;
		/* PRU system event 31, channel 0, host event 0 */
		interrupts = <31 0 0>, ...;
		interrupt-names = "kick", ...;
		...
	},

Then driver would request the IRQ during probe:

	data->kick_irq = of_irq_get_byname(dev, "kick");
	if (data->kick_irq < 0)
		...
	

And later the driver would use the IRQ to kick the PRU:

	irq_set_irqchip_state(data->kick_irq, IRQCHIP_STATE_PENDING, true);


>       irq_set_irqchip_state(irq, IRQCHIP_STATE_PENDING, true);
> 
> Signed-off-by: David Lechner <david at lechnology.com>
> Signed-off-by: Suman Anna <s-anna at ti.com>
> Signed-off-by: Grzegorz Jaszczyk <grzegorz.jaszczyk at linaro.org>
> Reviewed-by: Lee Jones <lee.jones at linaro.org>
> ---