[PATCH 17/33] ARM: dts: exynos: Override thermal by label in Galaxy I9000

[Krzysztof Kozlowski]

Using full paths to extend or override a device tree node is error prone
since if there was a typo error, a new node will be created instead of
extending the node as it was desired.  This will lead to run-time errors
that could be hard to detect.

A mistyped label on the other hand, will cause a dtc compile error
(during build time).

Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>
---
 arch/arm/boot/dts/exynos4210-i9100.dts | 28 ++++++++++++--------------
 1 file changed, 13 insertions(+), 15 deletions(-)

diff --git a/arch/arm/boot/dts/exynos4210-i9100.dts b/arch/arm/boot/dts/exynos4210-i9100.dts
index 5623e17889a5..799b69e1a93a 100644
--- a/arch/arm/boot/dts/exynos4210-i9100.dts
+++ b/arch/arm/boot/dts/exynos4210-i9100.dts
@@ -217,21 +217,6 @@
 			clock-frequency = <32768>;
 		};
 	};
-
-	thermal-zones {
-		cpu_thermal: cpu-thermal {
-			cooling-maps {
-				map0 {
-					/* Corresponds to 800MHz */
-					cooling-device = <&cpu0 2 2>;
-				};
-				map1 {
-					/* Corresponds to 200MHz */
-					cooling-device = <&cpu0 4 4>;
-				};
-			};
-		};
-	};
 };
 
 &camera {
@@ -242,6 +227,19 @@
 	cpu0-supply = <&varm_breg>;
 };
 
+&cpu_thermal {
+	cooling-maps {
+		map0 {
+			/* Corresponds to 800MHz */
+			cooling-device = <&cpu0 2 2>;
+		};
+		map1 {
+			/* Corresponds to 200MHz */
+			cooling-device = <&cpu0 4 4>;
+		};
+	};
+};
+
 &ehci {
 	status = "okay";
 
-- 
2.17.1