[PATCH 5/8] spi: spi-s3c64xx: Fix doc comment for struct s3c64xx_spi_driver_data

[Łukasz Stelmach]

Signed-off-by: Łukasz Stelmach <l.stelmach at samsung.com>
---
 drivers/spi/spi-s3c64xx.c | 10 ++++++----
 1 file changed, 6 insertions(+), 4 deletions(-)

diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index 6fe896f2be18..505789f91fdf 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -155,19 +155,21 @@ struct s3c64xx_spi_port_config {
  * @clk: Pointer to the spi clock.
  * @src_clk: Pointer to the clock used to generate SPI signals.
  * @ioclk: Pointer to the i/o clock between master and slave
+ * @pdev: Pointer to the SPI controller platform device
  * @master: Pointer to the SPI Protocol master.
  * @cntrlr_info: Platform specific data for the controller this driver manages.
  * @lock: Controller specific lock.
  * @state: Set of FLAGS to indicate status.
- * @rx_dmach: Controller's DMA channel for Rx.
- * @tx_dmach: Controller's DMA channel for Tx.
+ * @rx_dma: Controller's DMA channel for Rx.
+ * @tx_dma: Controller's DMA channel for Tx.
  * @sfr_start: BUS address of SPI controller regs.
  * @regs: Pointer to ioremap'ed controller registers.
- * @irq: interrupt
  * @xfer_completion: To indicate completion of xfer task.
  * @cur_mode: Stores the active configuration of the controller.
  * @cur_bpw: Stores the active bits per word settings.
  * @cur_speed: Stores the active xfer clock speed.
+ * @port_conf: Pointer to the SPI port configuration
+ * @port_id: SPI port ID number
  */
 struct s3c64xx_spi_driver_data {
 	void __iomem                    *regs;
@@ -176,7 +178,7 @@ struct s3c64xx_spi_driver_data {
 	struct clk                      *ioclk;
 	struct platform_device          *pdev;
 	struct spi_master               *master;
-	struct s3c64xx_spi_info  *cntrlr_info;
+	struct s3c64xx_spi_info         *cntrlr_info;
 	spinlock_t                      lock;
 	unsigned long                   sfr_start;
 	struct completion               xfer_completion;
-- 
2.26.2