[PATCH v6 00/13] irqchip: ti,sci-intr/inta: Update the dt bindings to accept different interrupt parents

[Lokesh Vutla]

Nishanth, Tero,

On 06/08/20 1:18 pm, Lokesh Vutla wrote:
> Hi Marc,
> 	This is continuation of the RFC patches[0] regarding the driver
> updates to support for following interrupt parent connection:
> - INTR -> INTR
> - INTA -> GICv3
> The current existing driver assumes that INTR is always connected to
> GICv3 and INTA is always connected to INTR.
> 
> As discussed this change breaks the DT backward compatibility but it
> allows to not depend on TISCI firmware properties in DT node. IMHO, this
> will ensure that any future changes will not effect DT properties.
> 
> This series depends on the the new Yaml bindings for common TISCI[1].
> 
> [0] https://lore.kernel.org/linux-arm-kernel/20190923042405.26064-1-lokeshvutla@ti.com/
> [1] https://patchwork.kernel.org/patch/11676843/
> 
> Tested with: (There is a build error on Today's master while building dtbs. So I enabled
> 	      only the TI specific components for building DTBS).
> - DT_SCHEMA_FILES="Documentation/devicetree/bindings/interrupt-controller/ti,sci-intr.yaml"
>   v8make dt_binding_check
> - DT_SCHEMA_FILES="Documentation/devicetree/bindings/interrupt-controller/ti,sci-inta.yaml"
>   v8make dt_binding_check
> - DT_SCHEMA_FILES="Documentation/devicetree/bindings/interrupt-controller/ti,sci-intr.yaml"
>   v8make dtbs_check
> - DT_SCHEMA_FILES="Documentation/devicetree/bindings/interrupt-controller/ti,sci-inta.yaml"
>   v8make dtbs_check
> - v8make allmodconfig
> 
> Changes since v5:
> - Rebased on latest master.
> - Collected Reviewed-by from Rob.
> - Included DT changes in the same series so that everything can be merged in a single go.
>   Without DT changes, there are regressions for DMA and other consumer peripherals so suggestion
>   is to merge everthing in a single go. DT changes apply cleanly on next and Linus's master
>   without any merge conflicts.

Can you Ack the DT patches?

Thanks and regards,
Lokesh