[PATCH v2] ARM64: dts: meson-axg: enable the eMMC controller

Kevin Hilman khilman at baylibre.com
Mon Apr 23 09:41:05 PDT 2018


On Thu, Apr 19, 2018 at 11:55 PM, Ulf Hansson <ulf.hansson at linaro.org> wrote:
> On 19 April 2018 at 19:58, Kevin Hilman <khilman at baylibre.com> wrote:
>> Yixun Lan <yixun.lan at amlogic.com> writes:
>>
>>> From: Nan Li <nan.li at amlogic.com>
>>>
>>> The IP of eMMC controller in AXG is similiar to Meson-GX series.
>>> Here we add the initial support of the HS200 mode with
>>> clock running at 166MHz (to be safe), since we found some eMMC chip
>>> fail to run at 200MHz due to tunning phase error.
>>>
>>> Signed-off-by: Nan Li <nan.li at amlogic.com>
>>> Signed-off-by: Yixun Lan <yixun.lan at amlogic.com>
>>
>> Applied to v4.18/dt64
>>
>>> ---
>>> Hi Kevin
>>>   Please note this patch actually depend on the eMMC driver here [0].
>>>   Still a few problem to solve, to improve the tuning phase driver to make
>>> the clock running at 200MHz, and to further support the HS400 mode.
>>> Anyway, this patch itself is quite independent.
>>
>> The driver changes are queued for v4.18 also.  Good!
>
> Right, may I consider that as an ack? :-)

I thought it was already merged while I was OoO, so I didn't bother to
reply with an ack, but if it's not too late, then yes:

Acked-by: Kevin Hilman <khilman at baylibre.com>

Kevin



More information about the linux-arm-kernel mailing list