[PATCH v5 2/4] clocksource: stm32: only use 32 bits timers

[Julien Thierry]

On 18/10/17 08:43, Benjamin Gaignard wrote:
> 16 bits hardware are not enough accure to be used.
> Do no allow them to be probed by tested max counter value.
> 
> Signed-off-by: Benjamin Gaignard <benjamin.gaignard at linaro.org>
> ---
>   drivers/clocksource/timer-stm32.c | 23 +++++++++--------------
>   1 file changed, 9 insertions(+), 14 deletions(-)
> 
> diff --git a/drivers/clocksource/timer-stm32.c b/drivers/clocksource/timer-stm32.c
> index abff21c..f7e4eec 100644
> --- a/drivers/clocksource/timer-stm32.c
> +++ b/drivers/clocksource/timer-stm32.c
> @@ -81,9 +81,9 @@ static irqreturn_t stm32_clock_event_handler(int irq, void *dev_id)
>   static int __init stm32_clockevent_init(struct device_node *node)
>   {
>   	struct reset_control *rstc;
> -	unsigned long max_delta;
> -	int ret, bits, prescaler = 1;
> +	unsigned long max_arr;
>   	struct timer_of *to;
> +	int ret;
>   
>   	to = kzalloc(sizeof(*to), GFP_KERNEL);
>   	if (!to)
> @@ -113,26 +113,21 @@ static int __init stm32_clockevent_init(struct device_node *node)
>   
>   	/* Detect whether the timer is 16 or 32 bits */
>   	writel_relaxed(~0U, timer_of_base(to) + TIM_ARR);
> -	max_delta = readl_relaxed(timer_of_base(to) + TIM_ARR);
> -	if (max_delta == ~0U) {
> -		prescaler = 1;
> -		bits = 32;
> -	} else {
> -		prescaler = 1024;
> -		bits = 16;
> +	max_arr = readl_relaxed(timer_of_base(to) + TIM_ARR);
> +	if (max_arr != ~0U) {
> +		pr_err("32 bits timer is needed\n");
> +		return -EINVAL;

Same as with previous patch, I think "to" should get freed.

Also, why is there no function to undo what timer_of_init did? Shouldn't 
we be able to free the irqs and unmap the timer io base here?

Cheers,

-- 
Julien Thierry