[PULL 04/13] KVM: arm/arm64: vgic-v2: Do not use Active+Pending state for a HW interrupt

[Christoffer Dall]

From: Marc Zyngier <marc.zyngier at arm.com>

When an interrupt is injected with the HW bit set (indicating that
deactivation should be propagated to the physical distributor),
special care must be taken so that we never mark the corresponding
LR with the Active+Pending state (as the pending state is kept in
the physycal distributor).

Cc: stable at vger.kernel.org
Fixes: 140b086dd197 ("KVM: arm/arm64: vgic-new: Add GICv2 world switch backend")
Signed-off-by: Marc Zyngier <marc.zyngier at arm.com>
Reviewed-by: Christoffer Dall <cdall at linaro.org>
Signed-off-by: Christoffer Dall <cdall at linaro.org>
---
 virt/kvm/arm/vgic/vgic-v2.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/virt/kvm/arm/vgic/vgic-v2.c b/virt/kvm/arm/vgic/vgic-v2.c
index a65757a..504b4bd 100644
--- a/virt/kvm/arm/vgic/vgic-v2.c
+++ b/virt/kvm/arm/vgic/vgic-v2.c
@@ -149,6 +149,13 @@ void vgic_v2_populate_lr(struct kvm_vcpu *vcpu, struct vgic_irq *irq, int lr)
 	if (irq->hw) {
 		val |= GICH_LR_HW;
 		val |= irq->hwintid << GICH_LR_PHYSID_CPUID_SHIFT;
+		/*
+		 * Never set pending+active on a HW interrupt, as the
+		 * pending state is kept at the physical distributor
+		 * level.
+		 */
+		if (irq->active && irq_is_pending(irq))
+			val &= ~GICH_LR_PENDING_BIT;
 	} else {
 		if (irq->config == VGIC_CONFIG_LEVEL)
 			val |= GICH_LR_EOI;
-- 
2.9.0